[PATCH v3 0/2] powerpc: Board support for GE Fanuc SBC610

[Martyn Welch]

The following series implements basic board support for GE Fanuc's SBC610, a 
6U single board computer, based on Freescale's MPC8641D.

This series provides basic functionality:
- The board can boot with a serial console.
- Ethernet works, though the phys are polled.
- The PCI bus is scanned and sata functions.

Signed-off-by: Martyn Welch <martyn.welch at gefanuc.com>
---

Kumar & Scott: Thanks again for your comments.

I have:
- Removed all of the "device_type" entries I believe I can
- Moved the default config to new directory "arch/powerpc/configs/86xx/"
- "mac-address" changed to "local-mac-address"
- Removed un-needed #add/size and other defunct entries
- Use common interrupt routine.

Martyn

Martyn Welch (2):
      powerpc: Default configuration for GE Fanuc SBC610
      powerpc: Board support for GE Fanuc SBC610


 arch/powerpc/boot/dts/gef_sbc610.dts      |  268 +++++
 arch/powerpc/configs/gef_sbc610_defconfig | 1654 +++++++++++++++++++++++++++++
 arch/powerpc/platforms/86xx/Kconfig       |    9 
 arch/powerpc/platforms/86xx/Makefile      |    1 
 arch/powerpc/platforms/86xx/gef_sbc610.c  |  187 +++
 5 files changed, 2118 insertions(+), 1 deletions(-)
 create mode 100644 arch/powerpc/boot/dts/gef_sbc610.dts
 create mode 100644 arch/powerpc/configs/gef_sbc610_defconfig
 create mode 100644 arch/powerpc/platforms/86xx/gef_sbc610.c