[PATCH] [POWERPC] mpc8568e_mds: UCC0's PHY is at 0x7, not 0x1

[Anton Vorontsov]

There was probably a typo in the documentation, or it's hw errata.
Recent u-boot also using 0x7.

Signed-off-by: Anton Vorontsov <avorontsov at ru.mvista.com>
---
 arch/powerpc/boot/dts/mpc8568mds.dts |    8 ++++----
 1 files changed, 4 insertions(+), 4 deletions(-)

diff --git a/arch/powerpc/boot/dts/mpc8568mds.dts b/arch/powerpc/boot/dts/mpc8568mds.dts
index b1dcfbe..719929c 100644
--- a/arch/powerpc/boot/dts/mpc8568mds.dts
+++ b/arch/powerpc/boot/dts/mpc8568mds.dts
@@ -97,10 +97,10 @@
 			device_type = "mdio";
 			compatible = "gianfar";
 			reg = <24520 20>;
-			phy0: ethernet-phy at 0 {
+			phy0: ethernet-phy at 7 {
 				interrupt-parent = <&mpic>;
 				interrupts = <1 1>;
-				reg = <0>;
+				reg = <7>;
 				device_type = "ethernet-phy";
 			};
 			phy1: ethernet-phy at 1 {
@@ -417,10 +417,10 @@
 
 			/* These are the same PHYs as on
 			 * gianfar's MDIO bus */
-			qe_phy0: ethernet-phy at 00 {
+			qe_phy0: ethernet-phy at 07 {
 				interrupt-parent = <&mpic>;
 				interrupts = <1 1>;
-				reg = <0>;
+				reg = <7>;
 				device_type = "ethernet-phy";
 			};
 			qe_phy1: ethernet-phy at 01 {
-- 
1.5.0.6