mmap on PPC removes file refcount?

[Dave Jiang]

NM, it was a bad test causing weird behavior on PPC. :(

Dave Jiang wrote:
> It seems the mmap() userland call on PPC causes the kernel to lose the ref
> count for the mount point. This is what I did on a prpmc2800 board (74xx) with
> latest powerpc.git tree (but also seem to happen on 8548 as well).
> 
> I mounted an IDE partition. The userland test app opens a file on the mounted
> partition and sits in a sleep loop while holding the file open. I call umount
> on the partition and I get "device is busy" which is suppose to happen.
> However, after the test app calls mmap on the file id for the opened file, I
> can successfully umount even though it should still say "device is busy".  This
> does not happen on x86 so I'm assuming something is going on with just PPC.
> 
> So using lsof I can list the opened files on a particular partition. When the
> file is opened, it lists 1 entry. When mmaped, on x86 it would list 2 entries,
> but on ppc it lists nothing. Not only did the mmaped entry not show up, the
> entry caused by open disappeared as well. Also, I put a printk in do_umount()
> to see what the refcount is. On x86, it would be 3 and thus causes device busy.
> On PPC it is 3 when the file is openend, however if mmap is called, the
> refcount becomes 2 and thus umount proceeds. It's almost as if the mmap call
> wiped out the opened file entry and decremented the mount count as well.
> 
> 


-- 

------------------------------------------------------
Dave Jiang
Software Engineer
MontaVista Software, Inc.
http://www.mvista.com
------------------------------------------------------