[PATCH] Read back MSI message in rtas_setup_msi_irqs() so restore works
linas at austin.ibm.com
Thu Nov 8 08:29:49 EST 2007
On Tue, Oct 23, 2007 at 02:23:44PM +1000, Michael Ellerman wrote:
> There are plans afoot to use pci_restore_msi_state() to restore MSI
> state after a device reset. In order for this to work for the RTAS MSI
> backend, we need to read back the MSI message from config space after
> it has been setup by firmware.
> This should be sufficient for restoring the MSI state after a device
> reset, however we will need to revisit this for suspend to disk if that
> is ever implemented on pseries.
> Signed-off-by: Michael Ellerman <michael at ellerman.id.au>
> Linas, can you test this on your setup with your EEH stuff? I haven't got
> any MSI supporting hardware/firmware combination.
Acked-by: Linas Vepstas <linas at austin.ibm.com>
I *finally* was able to get onto some hardware long enough to run this.
And that took a lot of work. Sigh. Yes, this is exactly what I'd wanted.
More information about the Linuxppc-dev