[patch 4/6] ps3: Disk Storage Driver

David Miller davem at davemloft.net
Sat Jun 16 09:37:18 EST 2007


From: James Bottomley <James.Bottomley at SteelEye.com>
Date: Fri, 15 Jun 2007 16:28:03 -0700

> On Fri, 2007-06-15 at 16:08 -0700, David Miller wrote:
> > From: James Bottomley <James.Bottomley at SteelEye.com>
> > Date: Fri, 15 Jun 2007 15:40:42 -0700
> > 
> > > On Fri, 2007-06-15 at 14:19 -0700, David Miller wrote:
> > > > Another quirk I have to deal with is that under LDOMs you
> > > > can export full disks and also just slices.  So I'll have
> > > > to get down into the partition machinery to support that
> > > > somehow.
> > > 
> > > For this, it sounds like you might find nbd a more enticing
> > > proposition ... it already is partition independent and is basically a
> > > block to net socket exporter.
> > 
> > That's not gonna work, it's a totally different model.
> > 
> > I have a predefined protocol over hypervisor provided "channels" and
> > page flipping also done by the hypervisor for the bulk data transfer.
> > For the client side I cannot change the hypervisor nor the server
> > speaking on the other end.  And when I do write a server I do want
> > it to be able to speak to all of the existing clients.
> > 
> > There's SCSI command pass through as well, as I keep mentioning as
> > it's an important reason I don't want to go with any of the non-SCSI
> > solutions (other than perhaps ATA) being suggested.
> 
> Then sure, use SCSI ... the ibmvscsi client originally talked to some
> type of hypervisor interface too before IBM extracted it and open
> sourced the server.  If actual SCSI commands are going in somewhere ...
> be it a real device, a RAID firmware emulation or a hypervisor input,
> then I'm happy with the driver being in SCSI.

For normal block I/O it's just raw copies over the provided protocol.

But the service exports a service by which raw SCSI commands can be
sent, for things like disk fault probing and stuff like that.  It's
not for block I/O, it's for "all the funny stuff" scsi comands are
used for outside of actual data transfers.



More information about the Linuxppc-dev mailing list