[PATCH 1/5] Add the explanation and sample of RapidIO DTS sector to the document of booting-without-of.txt file.

[Segher Boessenkool]

> +   k) RapidIO
> +
> +   Required properties:
> +
> +    - device_type : Should be "rapidio"

There is no OF binding, so no.

> +    - compatible : Should be "fsl,rapidio-v0.0" or "fsl,rapidio-v1.0"
> +      and so on. The version number is got from IP Block Revision
> +      Register of RapidIO controller.

It's better to use real device names, just like everyone
else.

> +    - #address-cells : Address representation for "rapidio" devices.
> +      This field represents the number of cells needed to represent
> +      the RapidIO address of the registers.  For supporting more than
> +      36-bits RapidIO address, this field should be <2>.

More than 32 bit?

> +    - interrupt-parent : the phandle for the interrupt controller that
> +      services interrupts for this device.

Not required, depends on the interrupt tree of the system.

> +    - interrupts : <a b> where a is the interrupt number and b is a
> +      field that represents an encoding of the sense and level
> +      information for the interrupt.

No.  The format of an "interrupts" entry is defined by
the interrupt domain this device sits in, not by the
device itself.

> For this sector, interrupts order should be
> +      <err_irq bell_outb_irq bell_inb_irq msg1_tx_irq msg1_rx_irq
> +      msg2_tx_irq msg2_rx_irq ... msgN_tx_irq msgN_rx_irq>.

That's to be defined in the binding for your specific device,
not in a more generic rapidio binding.

> +		#address-cells = <2>;

You want a #size-cells as well.

Hope this helps,


Segher