[Cbe-oss-dev] [RFC, PATCH] CELL Oprofile SPU profiling updated patch

Maynard Johnson maynardj at us.ibm.com
Fri Feb 16 11:32:48 EST 2007


Arnd Bergmann wrote:

>On Thursday 15 February 2007 00:52, Carl Love wrote:
>
>
>  
>
>>--- linux-2.6.20-rc1.orig/arch/powerpc/oprofile/Kconfig	2007-01-18 16:43:14.000000000 -0600
>>+++ linux-2.6.20-rc1/arch/powerpc/oprofile/Kconfig	2007-02-13 19:04:46.271028904 -0600
>>@@ -7,7 +7,8 @@
>> 
>> config OPROFILE
>> 	tristate "OProfile system profiling (EXPERIMENTAL)"
>>-	depends on PROFILING
>>+	default m
>>+	depends on SPU_FS && PROFILING
>> 	help
>> 	  OProfile is a profiling system capable of profiling the
>> 	  whole system, include the kernel, kernel modules, libraries,
>>    
>>
>
>Milton already commented on this being wrong. I think what you want
>is
>	depends on PROFILING && (SPU_FS = n || SPU_FS)
>
>that should make sure that when SPU_FS=y that OPROFILE can not be 'm'.
>  
>
The above suggestion would not work if SPU_FS is not defined, since the 
entire config option is ignored if an undefined symbol is used.  So, 
here's what I propose instead: 
    - Leave the existing 'config OPROFILE' unchanged from its current 
form in mainline (shown below)
    - Add the new 'config OPROFILE_CELL' (shown below)
    - In arch/powerpc/configs/cell-defconfig, set CONFIG_OPROFILE=m, to 
correspond to setting for CONFIG_SPU_FS
    - In arch/powerpc/oprofile/Makefile, do the following:
                oprofile-$(CONFIG_OPROFILE_CELL) += op_model_cell.o \
                                                            
cell/spu_profiler.o cell/vma_map.o cell/spu_task_sync.o

===========
config OPROFILE
        tristate "OProfile system profiling (EXPERIMENTAL)"
        depends on PROFILING
        help
          OProfile is a profiling system capable of profiling the
          whole system, include the kernel, kernel modules, libraries,
          and applications.

          If unsure, say N.

config OPROFILE_CELL
        bool "OProfile for Cell Broadband Engine"
        depends on OPROFILE && SPU_FS
        default y if ((SPU_FS = y && OPROFILE = y) || (SPU_FS = m && 
OPROFILE = m))
        help
          Profiling of Cell BE SPUs requires special support enabled
          by this option.  Both SPU_FS and OPROFILE options must be
          set 'y' or both be set 'm'.
=============

Can anyone see a problem with any of this . . . or perhaps a suggestion 
of a better way?

Thanks.

-Maynard




More information about the Linuxppc-dev mailing list