[PATCH, RFC] wake up from a serial port

[Scott Wood]

Guennadi Liakhovetski wrote:
> Well, sort of. One of them is more "natural" - it has a button on the 
> front panel, to use the other one you have to modify the hardware. 
> However, I like the idea - generally it does seem to be a better approach 
> to have it run-time configurable over sysfs... Only - how? The only 
> differentitaion ATM between the two ports are these two links:
> 
> # ls -l /sys/devices/platform/serial8250.0/tty*
> lrwxrwxrwx 1 root root 0 Aug 13 22:05 /sys/devices/platform/serial8250.0/tty:ttyS0 -> ../../../class/tty/ttyS0
> lrwxrwxrwx 1 root root 0 Aug 13 22:05 /sys/devices/platform/serial8250.0/tty:ttyS1 -> ../../../class/tty/ttyS1
> 
> And placing some wakeup file under the class/tty/ directory doesn't seem 
> very consistent with the current policy - until now they only live under 
> devices/... (Greg added to cc:).

Hmm... I'd assumed each port would have its own device directory.  Would 
anything break horribly if it were changed so that each tty:ttySx is a 
directory, which contains both a wakeup file and the symlink?

> Actually, it is good you replied, Scott:-) I wanted to ask you about the 
> following: I've switched to your generic suspend/resume routines using the 
> _TLF_NAPPING bit, the arch_suspend_{dis,en}able_irqs() hooks... On wakeup 
> your _TLF_NAPPING trick should bypass calling the ISR and jump directly to 
> the resume code. However, on wakeup, it looks like I do get the wakeup 
> interrupt too.

You should get the interrupt, but not until after the PM code enables 
IRQs.  Are you saying that the interrupt handler runs before then?

> Is it the correct behaviour and is this the (approximately) 
> correct explanation why:
> 
> 1. the AVR connected to ttyS0 sends 1 byte on button press and 1 byte on 
> button release. So, normally you would get 2 bytes and 2 interupts for one 
> such button down-up.
> 
> 2. Interrupt is configured as edge (is it correct - haven't found in 
> mpc8245um, UARTs are usually edge), so, 
> 
> --- button down -> byte #1 -> IRQ line active -> IC interrupts
> --- on resume interrupts are disabled, an EOI is performed (the line is 
> 	still active)
> --- interrupts are re-enabled 
> 
> 3. a second interrupt for the same byte is delivered.

No EOI is performed -- the idea is to defer the interrupt, not swallow 
it.  All that is done to defer the interrupt is clearing MSR[EE].

-Scott