Sequoia 440EPx patches not working

[Vitaly Bordug]

On Wed, 08 Aug 2007 13:45:10 -0500
Jerone Young wrote:

> Using the Sequoia (AMCC 440EPx) patches recently submitted to the
> list I am unable to boot to fully boot a uImage built with these
> patches under Uboot. It appears to hang in very early boot.
> 
> 
> Here is the output:
> => tftp 400000
> sequoia/uImage ENET Speed is 100 Mbps - FULL duplex connection
> (EMAC0) Using ppc_4xx_eth0
> device TFTP from server 9.53.41.24; our IP address is
> 9.53.41.38 Filename
> 'sequoia/uImage'. Load address:
> 0x400000 Loading:
> #################################################################
> #################################################################
> #################################################################
> #######################
> done Bytes transferred = 1112434 (10f972
> hex) => bootm
> 400000 ## Booting image at
> 00400000 ... Image Name:
> Linux-2.6.23-rc2 Image Type:   PowerPC Linux Kernel Image (gzip
> compressed) Data Size:    1112370 Bytes =  1.1
> MB Load Address:
> 00000000 Entry Point:
> 00000000 Verifying Checksum ...
> OK Uncompressing Kernel Image ... OK 
> 
> _______________________________________________
> Linuxppc-dev mailing list
> Linuxppc-dev at ozlabs.org
> https://ozlabs.org/mailman/listinfo/linuxppc-dev

This seems to be a wrong image..

Are you using "make zImage" ?

The proper uImage after that command would be smth like cuImage* then...

-- 
Sincerely, Vitaly