FEC driver not working after upgrade

[Mit Matelske]

I upgraded from an old 2.4.25 kernel to the latest Denx snapshot and cannot
get the ethernet to work.  I was previously running the FEC driver that used
the sdma interface.  I get a couple of interrupts and that is it.

Output when initializing:

mpc5xxx_fec_init
fec_priv c3f83160
MPC5200 I2S driver (16 BDs x 16 bytes).
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 8192)
mpc5xxx_fec_open
mpc5xxx_fec_restart
eth0: duplex set to 1
mii_queue: 600a0000 c0130bb0 00000000
mpc5xxx_fec_interrupt:
mpc5xxx_fec_mii 60080141 c0130bb0 00000000
mii_discover_phy
mii_queue: 600e0000 c0130abc 00000000
mpc5xxx_fec_interrupt:
mpc5xxx_fec_mii 600e0c87 c0130abc 00000000
eth0: Phy @ 0x0, type 88E6060 (0x01410c87)

Whenever I try to transmit anything I get:

mpc5xxx_fec_hard_start_xmit:
dev c3f83000, priv c3f83160, skb c3bcc860

The phy code works in the old fec driver fine, but I have tried the generic
phy driver also and it acts exactly the same.  

The major change was done by this patch back on Sept 4, 2005:

Modifications to the MPC5200 ATA and FEC drivers based on the
linuxppc_2_4_devel-fec+ata.patch and linux.habanero.fifo_cntrl.patch
patches from Freescale.

I am running a 5200B.  Thanks for any help.

Mit
-- 
View this message in context: http://www.nabble.com/FEC-driver-not-working-after-upgrade-tf4202285.html#a11952546
Sent from the linuxppc-dev mailing list archive at Nabble.com.