[PATCH 3/9] [POWERPC] Put mpc52xx support file in platforms/52xx

[Grant Likely]

platforms/embedded6xx is probably going away, and 52xx boards need some extra
support the 52xx interrupt controller and DMA engine anyway.  It makes sense
to group all the 52xx bits into a single path

Signed-off-by: Grant Likely <grant.likely at secretlab.ca>
Signed-off-by: Sylvain Munaut <tnt at 246tNt.com>
---
 arch/powerpc/Kconfig                       |    4 ++++
 arch/powerpc/platforms/embedded6xx/Kconfig |   12 ------------
 2 files changed, 4 insertions(+), 12 deletions(-)

diff --git a/arch/powerpc/Kconfig b/arch/powerpc/Kconfig
index c9949d9..2c6f8d1 100644
--- a/arch/powerpc/Kconfig
+++ b/arch/powerpc/Kconfig
@@ -408,6 +408,10 @@ config PPC_CHRP
 	select PPC_UDBG_16550
 	default y
 
+config PPC_MPC52xx
+	bool
+	default n
+
 config PPC_EFIKA
 	bool "bPlan Efika 5k2. MPC5200B based computer"
 	depends on PPC_MULTIPLATFORM && PPC32
diff --git a/arch/powerpc/platforms/embedded6xx/Kconfig b/arch/powerpc/platforms/embedded6xx/Kconfig
index 234a861..910d50a 100644
--- a/arch/powerpc/platforms/embedded6xx/Kconfig
+++ b/arch/powerpc/platforms/embedded6xx/Kconfig
@@ -146,15 +146,6 @@ config PQ2FADS
 	  Select PQ2FADS if you wish to configure for a Freescale
 	  PQ2FADS board (-VR or -ZU).
 
-config LITE5200
-	bool "Freescale LITE5200 / (IceCube)"
-	select PPC_MPC52xx
-	help
-	  Support for the LITE5200 dev board for the MPC5200 from Freescale.
-	  This is for the LITE5200 version 2.0 board. Don't know if it changes
-	  much but it's only been tested on this board version. I think this
-	  board is also known as IceCube.
-
 config EV64360
 	bool "Marvell-EV64360BP"
 	help
@@ -172,9 +163,6 @@ config TQM8xxL
 	depends on 8xx && (TQM823L || TQM850L || FPS850L || TQM855L || TQM860L)
 	default y
 
-config PPC_MPC52xx
-	bool
-
 config 8260
 	bool "CPM2 Support" if WILLOW
 	depends on 6xx
-- 
1.4.3.rc2.g0503