[PATCH 3/7] Have x86 use add_active_range() and free_area_init_nodes
Mel Gorman
mel at csn.ul.ie
Tue Apr 25 06:21:09 EST 2006
Size zones and holes in an architecture independent manner for x86.
This has been boot tested on;
x86 with 4 CPUs, flatmem
x86 on NUMAQ
It needs to be boot tested on an x86 machine that uses SRAT.
Kconfig | 8 +---
kernel/setup.c | 19 +++-------
kernel/srat.c | 98 ----------------------------------------------------
mm/discontig.c | 59 ++++---------------------------
4 files changed, 17 insertions(+), 167 deletions(-)
Signed-off-by: Mel Gorman <mel at csn.ul.ie>
diff -rup -X /usr/src/patchset-0.5/bin//dontdiff linux-2.6.17-rc2-102-powerpc_use_init_nodes/arch/i386/Kconfig linux-2.6.17-rc2-103-x86_use_init_nodes/arch/i386/Kconfig
--- linux-2.6.17-rc2-102-powerpc_use_init_nodes/arch/i386/Kconfig 2006-04-19 04:00:49.000000000 +0100
+++ linux-2.6.17-rc2-103-x86_use_init_nodes/arch/i386/Kconfig 2006-04-24 15:50:57.000000000 +0100
@@ -569,12 +569,10 @@ config ARCH_SELECT_MEMORY_MODEL
def_bool y
depends on ARCH_SPARSEMEM_ENABLE
-source "mm/Kconfig"
+config ARCH_POPULATES_NODE_MAP
+ def_bool y
-config HAVE_ARCH_EARLY_PFN_TO_NID
- bool
- default y
- depends on NUMA
+source "mm/Kconfig"
config HIGHPTE
bool "Allocate 3rd-level pagetables from highmem"
diff -rup -X /usr/src/patchset-0.5/bin//dontdiff linux-2.6.17-rc2-102-powerpc_use_init_nodes/arch/i386/kernel/setup.c linux-2.6.17-rc2-103-x86_use_init_nodes/arch/i386/kernel/setup.c
--- linux-2.6.17-rc2-102-powerpc_use_init_nodes/arch/i386/kernel/setup.c 2006-04-19 04:00:49.000000000 +0100
+++ linux-2.6.17-rc2-103-x86_use_init_nodes/arch/i386/kernel/setup.c 2006-04-24 15:50:57.000000000 +0100
@@ -1186,22 +1186,15 @@ static unsigned long __init setup_memory
void __init zone_sizes_init(void)
{
- unsigned long zones_size[MAX_NR_ZONES] = {0, 0, 0};
- unsigned int max_dma, low;
+ unsigned int max_dma;
+#ifndef CONFIG_HIGHMEM
+ unsigned long highend_pfn = max_low_pfn;
+#endif
max_dma = virt_to_phys((char *)MAX_DMA_ADDRESS) >> PAGE_SHIFT;
- low = max_low_pfn;
- if (low < max_dma)
- zones_size[ZONE_DMA] = low;
- else {
- zones_size[ZONE_DMA] = max_dma;
- zones_size[ZONE_NORMAL] = low - max_dma;
-#ifdef CONFIG_HIGHMEM
- zones_size[ZONE_HIGHMEM] = highend_pfn - low;
-#endif
- }
- free_area_init(zones_size);
+ add_active_range(0, 0, highend_pfn);
+ free_area_init_nodes(max_dma, max_dma, max_low_pfn, highend_pfn);
}
#else
extern unsigned long __init setup_memory(void);
diff -rup -X /usr/src/patchset-0.5/bin//dontdiff linux-2.6.17-rc2-102-powerpc_use_init_nodes/arch/i386/kernel/srat.c linux-2.6.17-rc2-103-x86_use_init_nodes/arch/i386/kernel/srat.c
--- linux-2.6.17-rc2-102-powerpc_use_init_nodes/arch/i386/kernel/srat.c 2006-04-19 04:00:49.000000000 +0100
+++ linux-2.6.17-rc2-103-x86_use_init_nodes/arch/i386/kernel/srat.c 2006-04-24 15:50:57.000000000 +0100
@@ -56,8 +56,6 @@ struct node_memory_chunk_s {
static struct node_memory_chunk_s node_memory_chunk[MAXCHUNKS];
static int num_memory_chunks; /* total number of memory chunks */
-static int zholes_size_init;
-static unsigned long zholes_size[MAX_NUMNODES * MAX_NR_ZONES];
extern void * boot_ioremap(unsigned long, unsigned long);
@@ -137,50 +135,6 @@ static void __init parse_memory_affinity
"enabled and removable" : "enabled" ) );
}
-#if MAX_NR_ZONES != 4
-#error "MAX_NR_ZONES != 4, chunk_to_zone requires review"
-#endif
-/* Take a chunk of pages from page frame cstart to cend and count the number
- * of pages in each zone, returned via zones[].
- */
-static __init void chunk_to_zones(unsigned long cstart, unsigned long cend,
- unsigned long *zones)
-{
- unsigned long max_dma;
- extern unsigned long max_low_pfn;
-
- int z;
- unsigned long rend;
-
- /* FIXME: MAX_DMA_ADDRESS and max_low_pfn are trying to provide
- * similarly scoped information and should be handled in a consistant
- * manner.
- */
- max_dma = virt_to_phys((char *)MAX_DMA_ADDRESS) >> PAGE_SHIFT;
-
- /* Split the hole into the zones in which it falls. Repeatedly
- * take the segment in which the remaining hole starts, round it
- * to the end of that zone.
- */
- memset(zones, 0, MAX_NR_ZONES * sizeof(long));
- while (cstart < cend) {
- if (cstart < max_dma) {
- z = ZONE_DMA;
- rend = (cend < max_dma)? cend : max_dma;
-
- } else if (cstart < max_low_pfn) {
- z = ZONE_NORMAL;
- rend = (cend < max_low_pfn)? cend : max_low_pfn;
-
- } else {
- z = ZONE_HIGHMEM;
- rend = cend;
- }
- zones[z] += rend - cstart;
- cstart = rend;
- }
-}
-
/*
* The SRAT table always lists ascending addresses, so can always
* assume that the first "start" address that you see is the real
@@ -233,7 +187,6 @@ static int __init acpi20_parse_srat(stru
memset(pxm_bitmap, 0, sizeof(pxm_bitmap)); /* init proximity domain bitmap */
memset(node_memory_chunk, 0, sizeof(node_memory_chunk));
- memset(zholes_size, 0, sizeof(zholes_size));
/* -1 in these maps means not available */
memset(pxm_to_nid_map, -1, sizeof(pxm_to_nid_map));
@@ -414,54 +367,3 @@ out_err:
printk("failed to get NUMA memory information from SRAT table\n");
return 0;
}
-
-/* For each node run the memory list to determine whether there are
- * any memory holes. For each hole determine which ZONE they fall
- * into.
- *
- * NOTE#1: this requires knowledge of the zone boundries and so
- * _cannot_ be performed before those are calculated in setup_memory.
- *
- * NOTE#2: we rely on the fact that the memory chunks are ordered by
- * start pfn number during setup.
- */
-static void __init get_zholes_init(void)
-{
- int nid;
- int c;
- int first;
- unsigned long end = 0;
-
- for_each_online_node(nid) {
- first = 1;
- for (c = 0; c < num_memory_chunks; c++){
- if (node_memory_chunk[c].nid == nid) {
- if (first) {
- end = node_memory_chunk[c].end_pfn;
- first = 0;
-
- } else {
- /* Record any gap between this chunk
- * and the previous chunk on this node
- * against the zones it spans.
- */
- chunk_to_zones(end,
- node_memory_chunk[c].start_pfn,
- &zholes_size[nid * MAX_NR_ZONES]);
- }
- }
- }
- }
-}
-
-unsigned long * __init get_zholes_size(int nid)
-{
- if (!zholes_size_init) {
- zholes_size_init++;
- get_zholes_init();
- }
- if (nid >= MAX_NUMNODES || !node_online(nid))
- printk("%s: nid = %d is invalid/offline. num_online_nodes = %d",
- __FUNCTION__, nid, num_online_nodes());
- return &zholes_size[nid * MAX_NR_ZONES];
-}
diff -rup -X /usr/src/patchset-0.5/bin//dontdiff linux-2.6.17-rc2-102-powerpc_use_init_nodes/arch/i386/mm/discontig.c linux-2.6.17-rc2-103-x86_use_init_nodes/arch/i386/mm/discontig.c
--- linux-2.6.17-rc2-102-powerpc_use_init_nodes/arch/i386/mm/discontig.c 2006-04-19 04:00:49.000000000 +0100
+++ linux-2.6.17-rc2-103-x86_use_init_nodes/arch/i386/mm/discontig.c 2006-04-24 15:50:57.000000000 +0100
@@ -157,21 +157,6 @@ static void __init find_max_pfn_node(int
BUG();
}
-/* Find the owning node for a pfn. */
-int early_pfn_to_nid(unsigned long pfn)
-{
- int nid;
-
- for_each_node(nid) {
- if (node_end_pfn[nid] == 0)
- break;
- if (node_start_pfn[nid] <= pfn && node_end_pfn[nid] >= pfn)
- return nid;
- }
-
- return 0;
-}
-
/*
* Allocate memory for the pg_data_t for this node via a crude pre-bootmem
* method. For node zero take this from the bottom of memory, for
@@ -352,45 +337,17 @@ unsigned long __init setup_memory(void)
void __init zone_sizes_init(void)
{
int nid;
-
+ unsigned long max_dma_pfn;
for_each_online_node(nid) {
- unsigned long zones_size[MAX_NR_ZONES] = {0, 0, 0};
- unsigned long *zholes_size;
- unsigned int max_dma;
-
- unsigned long low = max_low_pfn;
- unsigned long start = node_start_pfn[nid];
- unsigned long high = node_end_pfn[nid];
-
- max_dma = virt_to_phys((char *)MAX_DMA_ADDRESS) >> PAGE_SHIFT;
-
- if (node_has_online_mem(nid)){
- if (start > low) {
-#ifdef CONFIG_HIGHMEM
- BUG_ON(start > high);
- zones_size[ZONE_HIGHMEM] = high - start;
-#endif
- } else {
- if (low < max_dma)
- zones_size[ZONE_DMA] = low;
- else {
- BUG_ON(max_dma > low);
- BUG_ON(low > high);
- zones_size[ZONE_DMA] = max_dma;
- zones_size[ZONE_NORMAL] = low - max_dma;
-#ifdef CONFIG_HIGHMEM
- zones_size[ZONE_HIGHMEM] = high - low;
-#endif
- }
- }
- }
-
- zholes_size = get_zholes_size(nid);
-
- free_area_init_node(nid, NODE_DATA(nid), zones_size, start,
- zholes_size);
+ if (node_has_online_mem(nid))
+ add_active_range(nid, node_start_pfn[nid],
+ node_end_pfn[nid]);
}
+
+ max_dma_pfn = virt_to_phys((char *)MAX_DMA_ADDRESS) >> PAGE_SHIFT;
+ free_area_init_nodes(max_dma_pfn, max_dma_pfn,
+ max_low_pfn, highend_pfn);
return;
}
More information about the Linuxppc-dev
mailing list