[PATCH 0/7] [RFC] Sizing zones and holes in an architecture independent manner V2

[Mel Gorman]

This is V2 of the patchset. They have been boot tested on x86, ppc64
and x86_64 but I still need to do a double check that zones are the
same size before and after the patch on all arches. IA64 passed a
basic compile-test. a driver program that fed in the values generated
by IA64 to add_active_range(), zone_present_pages_in_node() and
zone_absent_pages_in_node() seemed to generate expected values.

Changelog since V1
o Correctly convert virtual and physical addresses to PFNs on ia64
o Correctly convert physical addresses to PFN on older ppc 
o When add_active_range() is called with overlapping pfn ranges, merge them
o When a zone boundary occurs within a memory hole, account correctly
o Minor whitespace damage cleanup
o Debugging patch temporarily included

At a basic level, architectures define structures to record where active
ranges of page frames are located. Once located, the code to calculate
zone sizes and holes in each architecture is very similar.  Some of this
zone and hole sizing code is difficult to read for no good reason. This
set of patches eliminates the similar-looking architecture-specific code.

The patches introduce a mechanism where architectures register where the
active ranges of page frames are with add_active_range(). When all areas
have been discovered, free_area_init_nodes() is called to initialise
the pgdat and zones. The zone sizes and holes are then calculated in an
architecture independent manner.

Patch 1 introduces the mechanism for registering and initialising PFN ranges
Patch 2 changes ppc to use the mechanism - 128 arch-specific LOC removed
Patch 3 changes x86 to use the mechanism - 150 arch-specific LOC removed
Patch 4 changes x86_64 to use the mechanism - 34 arch-specific LOC removed
Patch 5 changes ia64 to use the mechanism - 57 arch-specific LOC removed

At this point, there is a net reduction of 27 lines of code and the
arch-independent code is a lot easier to read in comparison to some of
the arch-specific stuff, particularly in arch/i386/ .

For Patch 6, it was also noted that page_alloc.c has a *lot* of
initialisation code which makes the file harder to read than it needs to
be. Patch 6 creates a new file mem_init.c and moves a lot of initialisation
code from page_alloc.c to it. After the patch is applied, there is still
a net reduction of 6 lines of code.

The patches have been successfully boot tested on

o x86, flatmem
o x86, NUMAQ
o PPC64, NUMA
o PPC64, CONFIG_NUMA=n
o x86_64, NUMA with SRAT

The patches have been compile tested for ia64 for flatmem and sparsemem
configurations. At attempt was made to boot test on an ancient RS/6000
but the vanilla kernel does not boot so I have to investigate there.

The net reduction seems small but the big benefit of this set of patches
is the reduction of 380 lines of architecture-specific code, some of
which is very hairy. There should be a greater net reduction when other
architectures use the same mechanisms for zone and hole sizing but I lack
the hardware to test on.

Comments?

Additional credit;
	Dave Hansen for the initial suggestion and comments on early patches
	Andy Whitcroft for reviewing early versions and catching numerous errors
	Tony Luck and Bob Picco for testing and debugging on IA64

 arch/i386/Kconfig          |    8 
 arch/i386/kernel/setup.c   |   19 
 arch/i386/kernel/srat.c    |   98 ----
 arch/i386/mm/discontig.c   |   59 --
 arch/ia64/Kconfig          |    3 
 arch/ia64/mm/contig.c      |   60 --
 arch/ia64/mm/discontig.c   |   41 -
 arch/ia64/mm/init.c        |   12 
 arch/powerpc/Kconfig       |   13 
 arch/powerpc/mm/mem.c      |   53 --
 arch/powerpc/mm/numa.c     |  157 ------
 arch/ppc/Kconfig           |    3 
 arch/ppc/mm/init.c         |   26 -
 arch/x86_64/Kconfig        |    3 
 arch/x86_64/kernel/e820.c  |   19 
 arch/x86_64/mm/init.c      |   60 --
 arch/x86_64/mm/numa.c      |   15 
 include/asm-ia64/meminit.h |    1 
 include/asm-x86_64/e820.h  |    1 
 include/asm-x86_64/proto.h |    2 
 include/linux/mm.h         |   14 
 include/linux/mmzone.h     |   15 
 mm/Makefile                |    2 
 mm/mem_init.c              | 1014 +++++++++++++++++++++++++++++++++++++++++++++
 mm/page_alloc.c            |  678 ------------------------------
 25 files changed, 1185 insertions(+), 1191 deletions(-)

-- 
-- 
Mel Gorman
Part-time Phd Student                          Linux Technology Center
University of Limerick                         IBM Dublin Software Lab