fail to disable MMU on ppc 8241

[llee]

Benjamin Herrenschmidt wrote:

>On Mon, 2004-04-19 at 13:55, llee wrote:
>
>
>>Hi, there,
>>I boot linux (2.6.3) on my ppc 8241 through vxworks bootloader. I'd got
>>a port (on address 0x70020006) to constrol three LEDs, so I could know
>>where the kernel going. But after the disable_mmu is called, I lost
>>control to the LEDs, Any suggestion on this? As I know, vxworks use a
>>one-to-one mapping MMU setup, I should must constrol the LEDs through
>>the same address.
>>
>>
>
>With mmu off, I suspect the 8241 acts as if the entire address space
>was cacheable, which is a BAD THING for IOs typically.
>
>Ben.
>
>
>
>
>
>
Thanks Ben, It works when I disable DATA CACHE!

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/