orinoco_cs on linuxppc_2_4/linux-2.4-benh
Josh Huber
huber at alum.wpi.edu
Fri Jan 18 13:38:10 EST 2002
I've decided to update the kernel on my laptop (Lombard 400),
currently it's running 2.4.11-pre4-ben0, which seems to work fine,
except I can't get usbmidi working with it.
usbmidi works (afaict) with the current 2.4.18-pre4(-ben0)? trees from
either linuxppc_2_4 or Ben's tree. However, both of them seem to
break my wireless card. The link to the base (an airport) appears to
be good, however no packets are transmitted/received over the link:
with the newer kernels:
iwconfig:
eth1 IEEE 802.11-DS ESSID:"huber_net" Nickname:"mystic"
Mode:Managed Frequency:2.412GHz Access Point: 00:60:1D:1D:3E:0E
Bit Rate:1Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Power Management:off
Link Quality:15/92 Signal level:-74 dBm Noise level:-89 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
dmesg:
hermes.c: 3 Oct 2001 David Gibson <hermes at gibson.dropbear.id.au>
orinoco.c 0.09a (David Gibson <hermes at gibson.dropbear.id.au> and others)
orinoco_cs.c 0.09 (David Gibson <hermes at gibson.dropbear.id.au> and others)
eth1: Station identity 001f:0001:0004:0034
eth1: Looks like a Lucent/Agere firmware version 4.52
eth1: Ad-hoc demo mode supported
eth1: WEP supported, 104-bit key
eth1: MAC address 00:60:1D:F1:04:67
eth1: Station name "HERMES I"
eth1: ready
eth1: index 0x01: Vcc 5.0, irq 22, io 0x0100-0x013f
Anyone else have this working with current kernels?
with the older kernel:
iwconfig:
eth1 IEEE 802.11-DS ESSID:"huber_net" Nickname:"mystic"
Mode:Managed Frequency:2.412GHz Access Point: 00:60:1D:1D:3E:0E
Bit Rate:11Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
dmesg:
hermes.c: 3 Oct 2001 David Gibson <hermes at gibson.dropbear.id.au>
orinoco.c 0.08 (David Gibson <hermes at gibson.dropbear.id.au> and others)
orinoco_cs.c 0.08 (David Gibson <hermes at gibson.dropbear.id.au> and others)
eth1: Station identity 001f:0001:0004:0034
eth1: Looks like a Lucent/Agere firmware version 4.52
eth1: Ad-hoc demo mode supported.
eth1: WEP supported, "128"-bit key.
eth1: MAC address 00:60:1D:F1:04:67
eth1: Station name "HERMES I"
eth1: Allowed channels mask: 0x000007ff
eth1: ready
eth1: index 0x01: Vcc 5.0, irq 22, io 0x0100-0x013f
If you need any more info, just ask,
--
Josh Huber
** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/
More information about the Linuxppc-dev
mailing list