MCP750 and CPX2000 System Scsi Woes

[VALETTE Eric]

>>>>> "Jim" == Jim Somerville <somer at nortelnetworks.com> writes:

Jim> pty: 256 Unix98 ptys configured
Jim> RAM disk driver initialized:  16 RAM disks of 4096K size
Jim> loop: registered device at major 7
Jim> ncr53c8xx: at PCI bus 0, device 16, function 0
Jim> ncr53c8xx: 53c825a detected 
Jim> ncr53c825a-0: rev=0x13, base=0x3bfffe00, io_port=0xffffe00, irq=0 <==================
Jim> ncr53c825a-0: ID 7, Fast-10, Parity Checking
Jim> ncr53c825a-0: on-chip RAM at 0x3bffe000
Jim> ncr53c825a-0: restart (scsi reset).
Jim> ncr53c825a-0: Downloading SCSI SCRIPTS.
Jim> scsi0 : ncr53c8xx - revision 3.1d
Jim> scsi : 1 host.
Jim> scsi : aborting command due to timeout : pid 0, scsi0, channel 0, id 0, lun 0 Test Unit Ready 00 00 00 00 00 
Jim> ncr53c8xx_abort: pid=0 serial_number=1 serial_number_at_timeout=1

You did not properly configure the interrupt routing table. See the file
in the kernel I sent you...


-- 
   __                 
  /  `                   	Eric Valette
 /--   __  o _.          	Canon CRF
(___, / (_(_(__         	Rue de la touche lambert
				35517 Cesson-Sevigne  Cedex
				FRANCE
Tel: +33 (0)2 99 87 68 91	Fax: +33 (0)2 99 84 11 30
E-mail: valette at crf.canon.fr

[[ This message was sent via the linuxppc-dev mailing list. Replies are ]]
[[ not forced back to the list, so be sure to  Cc linuxppc-dev  if your ]]
[[ reply is of general interest. To unsubscribe from linuxppc-dev, send ]]
[[ the message 'unsubscribe' to linuxppc-dev-request at lists.linuxppc.org ]]