Linux-2.1.129 boot on MCP750

[VALETTE Eric]

>>>>> "Cort" == Cort Dougan <cort at persephone.cs.nmt.edu> writes:

Cort> You can change the address that ppcbug loads the image to.  I pointed mine
Cort> at the end of memory to keep it out of the way.  The boot code for prep is
Cort> very delicate right now due to the many many addresses that boards load
Cort> the image at so anything that can make it easier (such as moving the
Cort> address the kernel is loaded at) I want to take advantage of.

I would like to have the instruction to make that.

Have a nice day,

-- eric

[[ This message was sent via the linuxppc-dev mailing list. Replies are ]]
[[ not forced back to the list, so be sure to  Cc linuxppc-dev  if your ]]
[[ reply is of general interest. To unsubscribe from linuxppc-dev, send ]]
[[ the message 'unsubscribe' to linuxppc-dev-request at lists.linuxppc.org ]]