[PATCH 08/36] gpio: aspeed: use new pinctrl GPIO helpers

[Bartosz Golaszewski]

From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>

Replace the pinctrl helpers taking the global GPIO number as argument
with the improved variants that instead take a pointer to the GPIO chip
and the controller-relative offset.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
---
 drivers/gpio/gpio-aspeed.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpio/gpio-aspeed.c b/drivers/gpio/gpio-aspeed.c
index da33bbbdacb9..d3aa1cfd4ace 100644
--- a/drivers/gpio/gpio-aspeed.c
+++ b/drivers/gpio/gpio-aspeed.c
@@ -750,12 +750,12 @@ static int aspeed_gpio_request(struct gpio_chip *chip, unsigned int offset)
 	if (!have_gpio(gpiochip_get_data(chip), offset))
 		return -ENODEV;
 
-	return pinctrl_gpio_request(chip->base + offset);
+	return pinctrl_gpio_request_new(chip, offset);
 }
 
 static void aspeed_gpio_free(struct gpio_chip *chip, unsigned int offset)
 {
-	pinctrl_gpio_free(chip->base + offset);
+	pinctrl_gpio_free_new(chip, offset);
 }
 
 static int usecs_to_cycles(struct aspeed_gpio *gpio, unsigned long usecs,
@@ -973,7 +973,7 @@ static int aspeed_gpio_set_config(struct gpio_chip *chip, unsigned int offset,
 	else if (param == PIN_CONFIG_BIAS_DISABLE ||
 			param == PIN_CONFIG_BIAS_PULL_DOWN ||
 			param == PIN_CONFIG_DRIVE_STRENGTH)
-		return pinctrl_gpio_set_config(offset, config);
+		return pinctrl_gpio_set_config_new(chip, offset, config);
 	else if (param == PIN_CONFIG_DRIVE_OPEN_DRAIN ||
 			param == PIN_CONFIG_DRIVE_OPEN_SOURCE)
 		/* Return -ENOTSUPP to trigger emulation, as per datasheet */
-- 
2.39.2