[PATCH] gpio: aspeed: fix the GPIO number passed to pinctrl_gpio_set_config()

Bartosz Golaszewski brgl at bgdev.pl
Tue Oct 3 18:39:26 AEDT 2023


From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>

pinctrl_gpio_set_config() expects the GPIO number from the global GPIO
numberspace, not the controller-relative offset, which needs to be added
to the chip base.

Fixes: 5ae4cb94b313 ("gpio: aspeed: Add debounce support")
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
---
 drivers/gpio/gpio-aspeed.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpio/gpio-aspeed.c b/drivers/gpio/gpio-aspeed.c
index da33bbbdacb9..58f107194fda 100644
--- a/drivers/gpio/gpio-aspeed.c
+++ b/drivers/gpio/gpio-aspeed.c
@@ -973,7 +973,7 @@ static int aspeed_gpio_set_config(struct gpio_chip *chip, unsigned int offset,
 	else if (param == PIN_CONFIG_BIAS_DISABLE ||
 			param == PIN_CONFIG_BIAS_PULL_DOWN ||
 			param == PIN_CONFIG_DRIVE_STRENGTH)
-		return pinctrl_gpio_set_config(offset, config);
+		return pinctrl_gpio_set_config(chip->base + offset, config);
 	else if (param == PIN_CONFIG_DRIVE_OPEN_DRAIN ||
 			param == PIN_CONFIG_DRIVE_OPEN_SOURCE)
 		/* Return -ENOTSUPP to trigger emulation, as per datasheet */
-- 
2.39.2



More information about the Linux-aspeed mailing list