[PATCH v3 2/6] dt-bindings: ipmi: bt-bmc: add 'clocks' as a required property
robh at kernel.org
Fri Nov 19 12:07:49 AEDT 2021
On Mon, 08 Nov 2021 11:01:56 -0800, jae.hyun.yoo at intel.com wrote:
> From: Jae Hyun Yoo <jae.hyun.yoo at linux.intel.com>
> If LPC BT driver is registered ahead of lpc-ctrl module, LPC BT
> hardware block will be enabled without heart beating of LCLK until
> lpc-ctrl enables the LCLK. This issue causes improper handling on
> host interrupts when the host sends interrupts in that time frame.
> Then kernel eventually forcibly disables the interrupt with
> dumping stack and printing a 'nobody cared this irq' message out.
> To prevent this issue, all LPC sub drivers should enable LCLK
> individually so this patch adds 'clocks' property as one of
> required properties to enable the LCLK by the LPC IBT driver.
> Note: dtsi change in this patch series should be applied along with,
> and dtbs should be re-compiled after applying this series since
> it's adding a new required property otherwise the driver will not
> be probed correctly.
> Signed-off-by: Jae Hyun Yoo <jae.hyun.yoo at linux.intel.com>
> v2 -> v3:
> * Made commit message more descriptive.
> v1 -> v2:
> * Added 'clocks' property into ibt bindings using
> 'aspeed,ast2400-ibt-bmc.txt' because it's not merged into
> 'aspeed-lpc.yaml' yet. The bindings merging could be done using a
> separate patch later.
> .../devicetree/bindings/ipmi/aspeed,ast2400-ibt-bmc.txt | 2 ++
> 1 file changed, 2 insertions(+)
Reviewed-by: Rob Herring <robh at kernel.org>
More information about the Linux-aspeed