[PATCH v2] pinctrl: aspeed: Fix GPI only function problem.

Billy Tsai billy_tsai at aspeedtech.com
Fri Oct 30 16:54:50 AEDT 2020


Some gpio pin at aspeed soc is input only and the prefix name of these
pin is "GPI" only.
This patch fine-tune the condition of GPIO check from "GPIO" to "GPI"
and it will fix the usage error of banks D and E in the AST2400/AST2500
and banks T and U in the AST2600.

Fixes: 4d3d0e4272d8 ("pinctrl: Add core support for Aspeed SoCs")

Signed-off-by: Billy Tsai <billy_tsai at aspeedtech.com>
---
 drivers/pinctrl/aspeed/pinctrl-aspeed.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/pinctrl/aspeed/pinctrl-aspeed.c b/drivers/pinctrl/aspeed/pinctrl-aspeed.c
index e03ee78b2434..95c8d400ad59 100644
--- a/drivers/pinctrl/aspeed/pinctrl-aspeed.c
+++ b/drivers/pinctrl/aspeed/pinctrl-aspeed.c
@@ -286,13 +286,14 @@ int aspeed_pinmux_set_mux(struct pinctrl_dev *pctldev, unsigned int function,
 static bool aspeed_expr_is_gpio(const struct aspeed_sig_expr *expr)
 {
 	/*
-	 * The signal type is GPIO if the signal name has "GPIO" as a prefix.
+	 * The signal type is GPIO if the signal name has "GPI" as a prefix.
 	 * strncmp (rather than strcmp) is used to implement the prefix
 	 * requirement.
 	 *
-	 * expr->signal might look like "GPIOT3" in the GPIO case.
+	 * expr->signal might look like "GPIOB1" in the GPIO case.
+	 * expr->signal might look like "GPIT0" in the GPI case.
 	 */
-	return strncmp(expr->signal, "GPIO", 4) == 0;
+	return strncmp(expr->signal, "GPI", 3) == 0;
 }
 
 static bool aspeed_gpio_in_exprs(const struct aspeed_sig_expr **exprs)
-- 
2.17.1



More information about the Linux-aspeed mailing list