[PATCH 3/5] i2c: aspeed: fix master pending state handling

[Jae Hyun Yoo]

In case of master pending state, it should not trigger the master
command because this H/W is sharing the same data buffer for slave
and master operations, so this commit fixes the issue with making
the master command triggering happen when the state goes to active
state.

Signed-off-by: Jae Hyun Yoo <jae.hyun.yoo at linux.intel.com>
---
 drivers/i2c/busses/i2c-aspeed.c | 9 +++++----
 1 file changed, 5 insertions(+), 4 deletions(-)

diff --git a/drivers/i2c/busses/i2c-aspeed.c b/drivers/i2c/busses/i2c-aspeed.c
index fa66951b05d0..40f6cf98d32e 100644
--- a/drivers/i2c/busses/i2c-aspeed.c
+++ b/drivers/i2c/busses/i2c-aspeed.c
@@ -336,18 +336,19 @@ static void aspeed_i2c_do_start(struct aspeed_i2c_bus *bus)
 	struct i2c_msg *msg = &bus->msgs[bus->msgs_index];
 	u8 slave_addr = i2c_8bit_addr_from_msg(msg);
 
-	bus->master_state = ASPEED_I2C_MASTER_START;
-
 #if IS_ENABLED(CONFIG_I2C_SLAVE)
 	/*
 	 * If it's requested in the middle of a slave session, set the master
 	 * state to 'pending' then H/W will continue handling this master
 	 * command when the bus comes back to the idle state.
 	 */
-	if (bus->slave_state != ASPEED_I2C_SLAVE_INACTIVE)
+	if (bus->slave_state != ASPEED_I2C_SLAVE_INACTIVE) {
 		bus->master_state = ASPEED_I2C_MASTER_PENDING;
+		return;
+	}
 #endif /* CONFIG_I2C_SLAVE */
 
+	bus->master_state = ASPEED_I2C_MASTER_START;
 	bus->buf_index = 0;
 
 	if (msg->flags & I2C_M_RD) {
@@ -432,7 +433,7 @@ static u32 aspeed_i2c_master_irq(struct aspeed_i2c_bus *bus, u32 irq_status)
 		if (bus->slave_state != ASPEED_I2C_SLAVE_INACTIVE)
 			goto out_no_complete;
 
-		bus->master_state = ASPEED_I2C_MASTER_START;
+		aspeed_i2c_do_start(bus);
 	}
 #endif /* CONFIG_I2C_SLAVE */
 
-- 
2.23.0