[PATCH v3 3/6] dt-bindings: mfd: da9062: add regulator voltage selection documentation
broonie at kernel.org
Mon Dec 16 22:44:54 AEDT 2019
On Mon, Dec 16, 2019 at 09:55:25AM +0100, Marco Felsch wrote:
> On 19-12-12 16:51, Mark Brown wrote:
> > Something needs to say what that thing is, especially if it's runtime
> > controllable. In your case from the point of view of software there is
> > actually no enable control so we shouldn't be providing an enable
> > operation to the framework.
> The enabel control signal is always available, please check  table
> 63. There is a mux in front of the enable pin so:
What I'm saying is that I think the binding needs to explicitly talk
about that since at the minute it's really confusing reading it as it
is, it sounds very much like it's trying to override that in a chip
specific fashion as using gpiolib and the GPIO bindings for pinmuxing is
really quite unusual.
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 488 bytes
Desc: not available
More information about the Linux-aspeed