[PATCH v2 2/3] ipmi: kcs: Finish configuring ASPEED KCS device before enable

[Andrew Jeffery]

The interrupts were configured after the channel was enabled. Configure
them beforehand so they will work.

Signed-off-by: Andrew Jeffery <andrew at aj.id.au>
Reviewed-by: Joel Stanley <joel at jms.id.au>
Reviewed-by: Haiyue Wang <haiyue.wang at linux.intel.com>
---
v2: Update the commit message based on Corey's suggestion

 drivers/char/ipmi/kcs_bmc_aspeed.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/char/ipmi/kcs_bmc_aspeed.c b/drivers/char/ipmi/kcs_bmc_aspeed.c
index 3c955946e647..e3dd09022589 100644
--- a/drivers/char/ipmi/kcs_bmc_aspeed.c
+++ b/drivers/char/ipmi/kcs_bmc_aspeed.c
@@ -268,13 +268,14 @@ static int aspeed_kcs_probe(struct platform_device *pdev)
 	kcs_bmc->io_inputb = aspeed_kcs_inb;
 	kcs_bmc->io_outputb = aspeed_kcs_outb;
 
+	rc = aspeed_kcs_config_irq(kcs_bmc, pdev);
+	if (rc)
+		return rc;
+
 	dev_set_drvdata(dev, kcs_bmc);
 
 	aspeed_kcs_set_address(kcs_bmc, addr);
 	aspeed_kcs_enable_channel(kcs_bmc, true);
-	rc = aspeed_kcs_config_irq(kcs_bmc, pdev);
-	if (rc)
-		return rc;
 
 	rc = misc_register(&kcs_bmc->miscdev);
 	if (rc) {
-- 
git-series 0.9.1