[PATCH v3 3/6] dt-bindings: mfd: da9062: add regulator voltage selection documentation

[Marco Felsch]

On 19-12-12 16:10, Mark Brown wrote:
> On Wed, Dec 11, 2019 at 06:09:18PM +0100, Marco Felsch wrote:
> 
> > so one argument more for my solution. Also we don't configure the "pad"
> > to be a vsel/ena-pin. The hw-pad can only be a gpio or has an alternate
> > function (WDKICK for GPIO0, Seq. SYS_EN for GPIO2, Seq. PWR_EN for GPIO4).
> > Instead we tell the regulator to use _this_ GPIO e.g. for voltage
> > selection so we go the other way around. My last argument why pinctrl
> > isn't the correct place is that the GPIO1 can be used for
> > regulator-0:vsel-in and for regulator-1:enable-in. So this pad would
> > have different states which is invalid IMHO.
> 
> Note that there's two bits to my concern - one is if we should be using
> gpiolib or pinctrl, the other is what's driving the input (whichever API
> it's configured through) which didn't seem to be mentioned.

gpiolib or pinctrl:
I pointed out all my arguments above so I think it is time for Linus.

"... what's driving the input ..":
Sorry I didn't get you here. What did you mean? The input is driven by
the host. This can be any gpio line and in my case it is a gpio line
driven by the soc-hw during a suspend operation.

Regards,
  Marco