[PATCH net-next v5] net/ncsi: Add NCSI Broadcom OEM command
Vijay Khemka
vijaykhemka at fb.com
Wed Oct 17 06:13:19 AEDT 2018
This patch adds OEM Broadcom commands and response handling. It also
defines OEM Get MAC Address handler to get and configure the device.
ncsi_oem_gma_handler_bcm: This handler send NCSI broadcom command for
getting mac address.
ncsi_rsp_handler_oem_bcm: This handles response received for all
broadcom OEM commands.
ncsi_rsp_handler_oem_bcm_gma: This handles get mac address response and
set it to device.
Signed-off-by: Vijay Khemka <vijaykhemka at fb.com>
---
net/ncsi/Kconfig | 6 ++++
net/ncsi/internal.h | 9 +++++
net/ncsi/ncsi-manage.c | 82 ++++++++++++++++++++++++++++++++++++++++++
net/ncsi/ncsi-pkt.h | 8 +++++
net/ncsi/ncsi-rsp.c | 44 +++++++++++++++++++++--
5 files changed, 147 insertions(+), 2 deletions(-)
diff --git a/net/ncsi/Kconfig b/net/ncsi/Kconfig
index 08a8a6031fd7..7f2b46108a24 100644
--- a/net/ncsi/Kconfig
+++ b/net/ncsi/Kconfig
@@ -10,3 +10,9 @@ config NET_NCSI
support. Enable this only if your system connects to a network
device via NCSI and the ethernet driver you're using supports
the protocol explicitly.
+config NCSI_OEM_CMD_GET_MAC
+ bool "Get NCSI OEM MAC Address"
+ depends on NET_NCSI
+ ---help---
+ This allows to get MAC address from NCSI firmware and set them back to
+ controller.
diff --git a/net/ncsi/internal.h b/net/ncsi/internal.h
index 13c9b5eeb3b7..1dae77c54009 100644
--- a/net/ncsi/internal.h
+++ b/net/ncsi/internal.h
@@ -71,6 +71,13 @@ enum {
/* OEM Vendor Manufacture ID */
#define NCSI_OEM_MFR_MLX_ID 0x8119
#define NCSI_OEM_MFR_BCM_ID 0x113d
+/* Broadcom specific OEM Command */
+#define NCSI_OEM_BCM_CMD_GMA 0x01 /* CMD ID for Get MAC */
+/* OEM Command payload lengths*/
+#define NCSI_OEM_BCM_CMD_GMA_LEN 12
+/* Mac address offset in OEM response */
+#define BCM_MAC_ADDR_OFFSET 28
+
struct ncsi_channel_version {
u32 version; /* Supported BCD encoded NCSI version */
@@ -246,6 +253,7 @@ enum {
ncsi_dev_state_probe_dp,
ncsi_dev_state_config_sp = 0x0301,
ncsi_dev_state_config_cis,
+ ncsi_dev_state_config_oem_gma,
ncsi_dev_state_config_clear_vids,
ncsi_dev_state_config_svf,
ncsi_dev_state_config_ev,
@@ -279,6 +287,7 @@ struct ncsi_dev_priv {
#define NCSI_DEV_PROBED 1 /* Finalized NCSI topology */
#define NCSI_DEV_HWA 2 /* Enabled HW arbitration */
#define NCSI_DEV_RESHUFFLE 4
+ unsigned int gma_flag; /* OEM GMA flag */
spinlock_t lock; /* Protect the NCSI device */
#if IS_ENABLED(CONFIG_IPV6)
unsigned int inet6_addr_num; /* Number of IPv6 addresses */
diff --git a/net/ncsi/ncsi-manage.c b/net/ncsi/ncsi-manage.c
index 6aa0614d2d28..bfc43b28c7a6 100644
--- a/net/ncsi/ncsi-manage.c
+++ b/net/ncsi/ncsi-manage.c
@@ -651,6 +651,72 @@ static int set_one_vid(struct ncsi_dev_priv *ndp, struct ncsi_channel *nc,
return 0;
}
+#if IS_ENABLED(CONFIG_NCSI_OEM_CMD_GET_MAC)
+
+/* NCSI OEM Command APIs */
+static int ncsi_oem_gma_handler_bcm(struct ncsi_cmd_arg *nca)
+{
+ unsigned char data[NCSI_OEM_BCM_CMD_GMA_LEN];
+ int ret = 0;
+
+ nca->payload = NCSI_OEM_BCM_CMD_GMA_LEN;
+
+ memset(data, 0, NCSI_OEM_BCM_CMD_GMA_LEN);
+ *(unsigned int *)data = ntohl(NCSI_OEM_MFR_BCM_ID);
+ data[5] = NCSI_OEM_BCM_CMD_GMA;
+
+ nca->data = data;
+
+ ret = ncsi_xmit_cmd(nca);
+ if (ret)
+ netdev_err(nca->ndp->ndev.dev,
+ "NCSI: Failed to transmit cmd 0x%x during configure\n",
+ nca->type);
+ return ret;
+}
+
+/* OEM Command handlers initialization */
+static struct ncsi_oem_gma_handler {
+ unsigned int mfr_id;
+ int (*handler)(struct ncsi_cmd_arg *nca);
+} ncsi_oem_gma_handlers[] = {
+ { NCSI_OEM_MFR_BCM_ID, ncsi_oem_gma_handler_bcm }
+};
+
+static int ncsi_gma_handler(struct ncsi_cmd_arg *nca, unsigned int mf_id)
+{
+ struct ncsi_oem_gma_handler *nch = NULL;
+ int i;
+
+ /* This function should only be called once, return if flag set */
+ if (nca->ndp->gma_flag == 1)
+ return -1;
+
+ /* Find gma handler for given manufacturer id */
+ for (i = 0; i < ARRAY_SIZE(ncsi_oem_gma_handlers); i++) {
+ if (ncsi_oem_gma_handlers[i].mfr_id == mf_id) {
+ if (ncsi_oem_gma_handlers[i].handler)
+ nch = &ncsi_oem_gma_handlers[i];
+ break;
+ }
+ }
+
+ if (!nch) {
+ netdev_err(nca->ndp->ndev.dev,
+ "NCSI: No GMA handler available for MFR-ID (0x%x)\n",
+ mf_id);
+ return -1;
+ }
+
+ /* Set the flag for GMA command which should only be called once */
+ nca->ndp->gma_flag = 1;
+
+ /* Get Mac address from NCSI device */
+ return nch->handler(nca);
+}
+
+#endif /* CONFIG_NCSI_OEM_CMD_GET_MAC */
+
static void ncsi_configure_channel(struct ncsi_dev_priv *ndp)
{
struct ncsi_dev *nd = &ndp->ndev;
@@ -701,7 +767,23 @@ static void ncsi_configure_channel(struct ncsi_dev_priv *ndp)
goto error;
}
+ nd->state = ncsi_dev_state_config_oem_gma;
+ break;
+ case ncsi_dev_state_config_oem_gma:
nd->state = ncsi_dev_state_config_clear_vids;
+ ret = -1;
+
+#if IS_ENABLED(CONFIG_NCSI_OEM_CMD_GET_MAC)
+ nca.type = NCSI_PKT_CMD_OEM;
+ nca.package = np->id;
+ nca.channel = nc->id;
+ ndp->pending_req_num = 1;
+ ret = ncsi_gma_handler(&nca, nc->version.mf_id);
+#endif /* CONFIG_NCSI_OEM_CMD_GET_MAC */
+
+ if (ret < 0)
+ schedule_work(&ndp->work);
+
break;
case ncsi_dev_state_config_clear_vids:
case ncsi_dev_state_config_svf:
diff --git a/net/ncsi/ncsi-pkt.h b/net/ncsi/ncsi-pkt.h
index 0f2087c8d42a..4d3f06be38bd 100644
--- a/net/ncsi/ncsi-pkt.h
+++ b/net/ncsi/ncsi-pkt.h
@@ -165,6 +165,14 @@ struct ncsi_rsp_oem_pkt {
unsigned char data[]; /* Payload data */
};
+/* Broadcom Response Data */
+struct ncsi_rsp_oem_bcm_pkt {
+ unsigned char ver; /* Payload Version */
+ unsigned char type; /* OEM Command type */
+ __be16 len; /* Payload Length */
+ unsigned char data[]; /* Cmd specific Data */
+};
+
/* Get Link Status */
struct ncsi_rsp_gls_pkt {
struct ncsi_rsp_pkt_hdr rsp; /* Response header */
diff --git a/net/ncsi/ncsi-rsp.c b/net/ncsi/ncsi-rsp.c
index 85fa59afae34..77e07ba3f493 100644
--- a/net/ncsi/ncsi-rsp.c
+++ b/net/ncsi/ncsi-rsp.c
@@ -611,19 +611,59 @@ static int ncsi_rsp_handler_snfc(struct ncsi_request *nr)
return 0;
}
+/* Response handler for Broadcom command Get Mac Address */
+static int ncsi_rsp_handler_oem_bcm_gma(struct ncsi_request *nr)
+{
+ struct ncsi_dev_priv *ndp = nr->ndp;
+ struct net_device *ndev = ndp->ndev.dev;
+ const struct net_device_ops *ops = ndev->netdev_ops;
+ struct ncsi_rsp_oem_pkt *rsp;
+ struct sockaddr saddr;
+ int ret = 0;
+
+ /* Get the response header */
+ rsp = (struct ncsi_rsp_oem_pkt *)skb_network_header(nr->rsp);
+
+ saddr.sa_family = ndev->type;
+ ndev->priv_flags |= IFF_LIVE_ADDR_CHANGE;
+ memcpy(saddr.sa_data, &rsp->data[BCM_MAC_ADDR_OFFSET], ETH_ALEN);
+ /* Increase mac address by 1 for BMC's address */
+ saddr.sa_data[ETH_ALEN - 1]++;
+ ret = ops->ndo_set_mac_address(ndev, &saddr);
+ if (ret < 0)
+ netdev_warn(ndev, "NCSI: 'Writing mac address to device failed\n");
+
+ return ret;
+}
+
+/* Response handler for Broadcom card */
+static int ncsi_rsp_handler_oem_bcm(struct ncsi_request *nr)
+{
+ struct ncsi_rsp_oem_bcm_pkt *bcm;
+ struct ncsi_rsp_oem_pkt *rsp;
+
+ /* Get the response header */
+ rsp = (struct ncsi_rsp_oem_pkt *)skb_network_header(nr->rsp);
+ bcm = (struct ncsi_rsp_oem_bcm_pkt *)(rsp->data);
+
+ if (bcm->type == NCSI_OEM_BCM_CMD_GMA)
+ return ncsi_rsp_handler_oem_bcm_gma(nr);
+ return 0;
+}
+
static struct ncsi_rsp_oem_handler {
unsigned int mfr_id;
int (*handler)(struct ncsi_request *nr);
} ncsi_rsp_oem_handlers[] = {
{ NCSI_OEM_MFR_MLX_ID, NULL },
- { NCSI_OEM_MFR_BCM_ID, NULL }
+ { NCSI_OEM_MFR_BCM_ID, ncsi_rsp_handler_oem_bcm }
};
/* Response handler for OEM command */
static int ncsi_rsp_handler_oem(struct ncsi_request *nr)
{
- struct ncsi_rsp_oem_pkt *rsp;
struct ncsi_rsp_oem_handler *nrh = NULL;
+ struct ncsi_rsp_oem_pkt *rsp;
unsigned int mfr_id, i;
/* Get the response header */
--
2.17.1
More information about the Linux-aspeed
mailing list