[PATCH 1/3] dt-bindings: aspeed-lpc: Add reset controller

[Philipp Zabel]

On Mon, 2018-02-19 at 17:24 +1030, Joel Stanley wrote:
> This describes the reset controller present in the LPC address space.
> 
> Signed-off-by: Joel Stanley <joel at jms.id.au>
> ---
>  .../devicetree/bindings/mfd/aspeed-lpc.txt          | 21 +++++++++++++++++++++
>  1 file changed, 21 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/mfd/aspeed-lpc.txt b/Documentation/devicetree/bindings/mfd/aspeed-lpc.txt
> index 514d82ced95b..721a2b1eb40f 100644
> --- a/Documentation/devicetree/bindings/mfd/aspeed-lpc.txt
> +++ b/Documentation/devicetree/bindings/mfd/aspeed-lpc.txt
> @@ -135,3 +135,24 @@ lhc: lhc at 20 {
>  	compatible = "aspeed,ast2500-lhc";
>  	reg = <0x20 0x24 0x48 0x8>;
>  };
> +
> +LPC reset control
> +-----------------
> +
> +The UARTs present in the ASPEED SoC can have their resets tied to the reset
> +state of the LPC bus. Some systems may chose to modify this configuration.
> +
> +Required properties:
> +
> + - comaptible:		"aspeed,ast2500-lpc-reset" or

"compatible"

> + 			"aspeed,ast2400-lpc-reset"
> + - reg:			offset and length of the IP in the LHC memory region
> + - #reset-controller	indacates the number of reset cells excepted

"indicates", "expected"

> +
> +Example:
> +
> +lpc_reset: reset-controller at 18 {
> +        compatible = "aspeed,ast2500-lpc-reset";
> +        reg = <0x18 0x4>;
> +        #reset-cells = <1>;
> +};

Should this mention or indicate in the example that the reset-controller 
node must be child of (a subnode of) the lpc node?

regards
Philipp