[PATCH 2/2] dt-bindings: edac: Aspeed AST2500

[Rob Herring]

On Sun, Dec 16, 2018 at 10:01:57PM -0800, Stefan Schaeckeler wrote:
> From: Stefan M Schaeckeler <sschaeck at cisco.com>
> 
> Add support for the Aspeed AST2500 SoC EDAC driver.
> 
> Signed-off-by: Stefan M Schaeckeler <sschaeck at cisco.com>
> ---
>  .../bindings/edac/aspeed-sdram-edac.txt       | 34 +++++++++++++++++++
>  1 file changed, 34 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt
> 
> diff --git a/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt b/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt
> new file mode 100644
> index 000000000000..57ba852883c7
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt
> @@ -0,0 +1,34 @@
> +Aspeed AST2500 SoC EDAC device driver

Bindings are for h/w, not drivers

> +
> +The Aspeed AST2500 SoC supports DDR3 and DDR4 memory with and without ECC (error
> +correction check).
> +
> +The memory controller supports SECDED (single bit error correction, double bit
> +error detection) and single bit error auto scrubbing by reserving 8 bits for
> +every 64 bit word (effectively reducing available memory to 8/9).
> +
> +First, ECC must be configured in u-boot. Then, this driver will expose error
> +counters via the edac kernel framework.

Please reword this to not be u-boot or kernel specific.

Maybe this node is enabled in the bootloader or the OS can just read the 
registers to see if ECC is enabled. The latter is more future proof if 
you need to access the DDR ctrl registers for other reasons.

> +
> +A note on memory organization in ECC mode: every 512 bytes are followed by 64
> +bytes of ECC codes. 

That sounds strange. Normally, the memory would be 72-bits wide to hold 
the ECC byte for each 64-bit chunk. It would be inefficient to access 
the ECC byte in a discontiguous location. In any case, none of this is 
really important for the binding.

> The address remapping is done in hardware and is fully
> +transparent to firmware and software. Because of this, ECC mode must be
> +configured in u-boot as part of the memory initialization as one can not switch
> +from one mode to another when executing in memory.
> +
> +
> +
> +Required properties:
> +- compatible: should be "aspeed,ast2500-sdram-edac"
> +- reg:        sdram controller register set should be <0x1e6e0000 0x174>
> +- interrupts: should be AVIC interrupt #0
> +
> +
> +Example:
> +
> +	edac: sdram at 1e6e0000 {
> +		compatible = "aspeed,ast2500-sdram-edac";
> +		reg = <0x1e6e0000 0x174>;
> +		interrupts = <0>;
> +		status = "okay";

Don't show status in examples.

> +	};
> -- 
> 2.19.1
>