[PATCH v2] usb: dwc3: use extcon fwrk to receive connect/disconnect notification
Kishon Vijay Abraham I
kishon at ti.com
Mon May 27 23:35:40 EST 2013
Modified dwc3-omap to receive connect and disconnect notification using
extcon framework. Also did the necessary cleanups required after
adapting to extcon framework.
Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
Acked-by: Chanwoo Choi <cw00.choi at samsung.com>
---
Changes from v1:
* regulator enable/disable is now done here instead of palmas-usb as some users
of palmas-usb wont need regulator.
drivers/usb/dwc3/dwc3-omap.c | 103 ++++++++++++++++++++++++++++++++++--------
include/linux/usb/dwc3-omap.h | 30 ------------
2 files changed, 85 insertions(+), 48 deletions(-)
delete mode 100644 include/linux/usb/dwc3-omap.h
diff --git a/drivers/usb/dwc3/dwc3-omap.c b/drivers/usb/dwc3/dwc3-omap.c
index 34638b9..158f903 100644
--- a/drivers/usb/dwc3/dwc3-omap.c
+++ b/drivers/usb/dwc3/dwc3-omap.c
@@ -43,13 +43,14 @@
#include <linux/spinlock.h>
#include <linux/platform_device.h>
#include <linux/platform_data/dwc3-omap.h>
-#include <linux/usb/dwc3-omap.h>
#include <linux/pm_runtime.h>
#include <linux/dma-mapping.h>
#include <linux/ioport.h>
#include <linux/io.h>
#include <linux/of.h>
#include <linux/of_platform.h>
+#include <linux/extcon.h>
+#include <linux/regulator/consumer.h>
#include <linux/usb/otg.h>
@@ -124,9 +125,21 @@ struct dwc3_omap {
u32 utmi_otg_status;
u32 dma_status:1;
+
+ struct extcon_specific_cable_nb extcon_vbus_dev;
+ struct extcon_specific_cable_nb extcon_id_dev;
+ struct notifier_block vbus_nb;
+ struct notifier_block id_nb;
+
+ struct regulator *vbus_reg;
};
-static struct dwc3_omap *_omap;
+enum omap_dwc3_vbus_id_status {
+ OMAP_DWC3_ID_FLOAT,
+ OMAP_DWC3_ID_GROUND,
+ OMAP_DWC3_VBUS_OFF,
+ OMAP_DWC3_VBUS_VALID,
+};
static inline u32 dwc3_omap_readl(void __iomem *base, u32 offset)
{
@@ -138,18 +151,21 @@ static inline void dwc3_omap_writel(void __iomem *base, u32 offset, u32 value)
writel(value, base + offset);
}
-int dwc3_omap_mailbox(enum omap_dwc3_vbus_id_status status)
+static void dwc3_omap_set_mailbox(struct dwc3_omap *omap,
+ enum omap_dwc3_vbus_id_status status)
{
- u32 val;
- struct dwc3_omap *omap = _omap;
-
- if (!omap)
- return -EPROBE_DEFER;
+ int ret;
+ u32 val;
switch (status) {
case OMAP_DWC3_ID_GROUND:
dev_dbg(omap->dev, "ID GND\n");
+ ret = regulator_enable(omap->vbus_reg);
+ if (ret) {
+ dev_dbg(omap->dev, "regulator enable failed\n");
+ return;
+ }
val = dwc3_omap_readl(omap->base, USBOTGSS_UTMI_OTG_STATUS);
val &= ~(USBOTGSS_UTMI_OTG_STATUS_IDDIG
| USBOTGSS_UTMI_OTG_STATUS_VBUSVALID
@@ -162,6 +178,11 @@ int dwc3_omap_mailbox(enum omap_dwc3_vbus_id_status status)
case OMAP_DWC3_VBUS_VALID:
dev_dbg(omap->dev, "VBUS Connect\n");
+ ret = regulator_enable(omap->vbus_reg);
+ if (ret) {
+ dev_dbg(omap->dev, "regulator enable failed\n");
+ return;
+ }
val = dwc3_omap_readl(omap->base, USBOTGSS_UTMI_OTG_STATUS);
val &= ~USBOTGSS_UTMI_OTG_STATUS_SESSEND;
val |= USBOTGSS_UTMI_OTG_STATUS_IDDIG
@@ -182,15 +203,13 @@ int dwc3_omap_mailbox(enum omap_dwc3_vbus_id_status status)
val |= USBOTGSS_UTMI_OTG_STATUS_SESSEND
| USBOTGSS_UTMI_OTG_STATUS_IDDIG;
dwc3_omap_writel(omap->base, USBOTGSS_UTMI_OTG_STATUS, val);
+ regulator_disable(omap->vbus_reg);
break;
default:
- dev_dbg(omap->dev, "ID float\n");
+ dev_dbg(omap->dev, "invalid state\n");
}
-
- return 0;
}
-EXPORT_SYMBOL_GPL(dwc3_omap_mailbox);
static irqreturn_t dwc3_omap_interrupt(int irq, void *_omap)
{
@@ -282,6 +301,32 @@ static void dwc3_omap_disable_irqs(struct dwc3_omap *omap)
static u64 dwc3_omap_dma_mask = DMA_BIT_MASK(32);
+static int dwc3_omap_id_notifier(struct notifier_block *nb,
+ unsigned long event, void *ptr)
+{
+ struct dwc3_omap *omap = container_of(nb, struct dwc3_omap, id_nb);
+
+ if (event)
+ dwc3_omap_set_mailbox(omap, OMAP_DWC3_ID_GROUND);
+ else
+ dwc3_omap_set_mailbox(omap, OMAP_DWC3_ID_FLOAT);
+
+ return NOTIFY_DONE;
+}
+
+static int dwc3_omap_vbus_notifier(struct notifier_block *nb,
+ unsigned long event, void *ptr)
+{
+ struct dwc3_omap *omap = container_of(nb, struct dwc3_omap, vbus_nb);
+
+ if (event)
+ dwc3_omap_set_mailbox(omap, OMAP_DWC3_VBUS_VALID);
+ else
+ dwc3_omap_set_mailbox(omap, OMAP_DWC3_VBUS_OFF);
+
+ return NOTIFY_DONE;
+}
+
static int dwc3_omap_probe(struct platform_device *pdev)
{
struct device_node *node = pdev->dev.of_node;
@@ -289,6 +334,8 @@ static int dwc3_omap_probe(struct platform_device *pdev)
struct dwc3_omap *omap;
struct resource *res;
struct device *dev = &pdev->dev;
+ struct extcon_dev *edev;
+ struct regulator *vbus_reg;
int ret = -ENOMEM;
int irq;
@@ -330,19 +377,32 @@ static int dwc3_omap_probe(struct platform_device *pdev)
return -ENOMEM;
}
+ edev = extcon_get_extcon_dev("palmas-usb");
+ if (!edev) {
+ dev_dbg(dev, "couldn't get extcon device\n");
+ return -EPROBE_DEFER;
+ }
+
+ vbus_reg = devm_regulator_get(&pdev->dev, "vbus");
+ if (IS_ERR(vbus_reg)) {
+ dev_err(dev, "vbus init failed\n");
+ return PTR_ERR(vbus_reg);
+ }
+
spin_lock_init(&omap->lock);
omap->dev = dev;
omap->irq = irq;
omap->base = base;
+ omap->vbus_reg = vbus_reg;
+ omap->vbus_nb.notifier_call = dwc3_omap_vbus_notifier;
+ extcon_register_interest(&omap->extcon_vbus_dev, "palmas-usb", "USB",
+ &omap->vbus_nb);
+ omap->id_nb.notifier_call = dwc3_omap_id_notifier;
+ extcon_register_interest(&omap->extcon_id_dev, "palmas-usb", "USB-HOST",
+ &omap->id_nb);
dev->dma_mask = &dwc3_omap_dma_mask;
- /*
- * REVISIT if we ever have two instances of the wrapper, we will be
- * in big trouble
- */
- _omap = omap;
-
pm_runtime_enable(dev);
ret = pm_runtime_get_sync(dev);
if (ret < 0) {
@@ -387,6 +447,11 @@ static int dwc3_omap_probe(struct platform_device *pdev)
return ret;
}
+ if (extcon_get_cable_state(edev, "USB") == true)
+ dwc3_omap_set_mailbox(omap, OMAP_DWC3_VBUS_VALID);
+ if (extcon_get_cable_state(edev, "USB-HOST") == true)
+ dwc3_omap_set_mailbox(omap, OMAP_DWC3_ID_GROUND);
+
return 0;
}
@@ -394,6 +459,8 @@ static int dwc3_omap_remove(struct platform_device *pdev)
{
struct dwc3_omap *omap = platform_get_drvdata(pdev);
+ extcon_unregister_interest(&omap->extcon_vbus_dev);
+ extcon_unregister_interest(&omap->extcon_id_dev);
dwc3_omap_disable_irqs(omap);
pm_runtime_put_sync(&pdev->dev);
pm_runtime_disable(&pdev->dev);
diff --git a/include/linux/usb/dwc3-omap.h b/include/linux/usb/dwc3-omap.h
deleted file mode 100644
index 5615f4d..0000000
--- a/include/linux/usb/dwc3-omap.h
+++ /dev/null
@@ -1,30 +0,0 @@
-/*
- * Copyright (C) 2013 by Texas Instruments
- *
- * The Inventra Controller Driver for Linux is free software; you
- * can redistribute it and/or modify it under the terms of the GNU
- * General Public License version 2 as published by the Free Software
- * Foundation.
- */
-
-#ifndef __DWC3_OMAP_H__
-#define __DWC3_OMAP_H__
-
-enum omap_dwc3_vbus_id_status {
- OMAP_DWC3_UNKNOWN = 0,
- OMAP_DWC3_ID_GROUND,
- OMAP_DWC3_ID_FLOAT,
- OMAP_DWC3_VBUS_VALID,
- OMAP_DWC3_VBUS_OFF,
-};
-
-#if (defined(CONFIG_USB_DWC3) || defined(CONFIG_USB_DWC3_MODULE))
-extern int dwc3_omap_mailbox(enum omap_dwc3_vbus_id_status status);
-#else
-static inline int dwc3_omap_mailbox(enum omap_dwc3_vbus_id_status status)
-{
- return -ENODEV;
-}
-#endif
-
-#endif /* __DWC3_OMAP_H__ */
--
1.8.1.2
More information about the devicetree-discuss
mailing list