[PATCH 3/5] ARM: dts: OMAP2+: convert DT files to use the new OMAP_GPIO macro

[Florian Vaussard]

Hi Stepen,

Thank you for your review,

On 05/22/2013 05:28 PM, Stephen Warren wrote:
> On 05/22/2013 08:27 AM, Florian Vaussard wrote:
>> Use OMAP_GPIO(), in conjunction with standard GPIO flags, to enhance the
>> readability of DT GPIOs.
>
>> diff --git a/arch/arm/boot/dts/omap3-beagle-xm.dts b/arch/arm/boot/dts/omap3-beagle-xm.dts
>> index e0ce823..e773a5e 100644
>> --- a/arch/arm/boot/dts/omap3-beagle-xm.dts
>> +++ b/arch/arm/boot/dts/omap3-beagle-xm.dts
>> @@ -29,13 +29,13 @@
>>
>>   		heartbeat {
>>   			label = "beagleboard::usr0";
>> -			gpios = <&gpio5 22 0>; /* 150 -> D6 LED */
>> +			gpios = OMAP_GPIO(150, GPIO_ACTIVE_HIGH); /* 150 -> D6 LED */
>
> One of the advantages of cpp support for me is the ability to remove the
> redundant part of the command. In other words, perhaps remove the "150
> ->" since that information is part of the OMAP_GPIO() "call", leaving
> just /* D6 LED */. I might have expected "D6" to be the label too, thus
> removing any need for the comment.
>

I agree. I removed almost all the comments from the other files. For 
here, I would
leave /* D6 LED */ as you suggest.

Regards,

Florian