[PATCH 2/5] ARM: dts: OMAP2+: create a DT header for GPIO

[Florian Vaussard]

Hello Stephan, Tony,

Thank you for your reviews.

On 05/22/2013 05:34 PM, Tony Lindgren wrote:
> * Stephen Warren <swarren at wwwdotorg.org> [130522 08:32]:
>> On 05/22/2013 08:27 AM, Florian Vaussard wrote:
>>> Define the OMAP_GPIO macro to conveniently use GPIO inside OMAP DT.
>>> For example:
>>>
>>> 	gpios = <&gpio6 3 0>;  /* GPIO 163 */
>>>
>>> can be replaced by
>>>
>>> 	gpios = OMAP_GPIO(163, 0);
>>
>>> diff --git a/include/dt-bindings/gpio/omap-gpio.h b/include/dt-bindings/gpio/omap-gpio.h
>>
>>> +#define OMAP_GPIO_0_BANK        gpio1
>>> +#define OMAP_GPIO_1_BANK        gpio1
>>> +#define OMAP_GPIO_2_BANK        gpio1
>>> +#define OMAP_GPIO_3_BANK        gpio1
>>
>> There are a /lot/ of those. Is this really worth it?
>>
>> If the OMAP GPIO HW is already represented as a bunch of separate DT
>> nodes which represent separate GPIO blocks, then I would have thought
>> the syntax <&gpioN M 0> more directly represents what would be found in
>> the HW manual? If not, surely the DT should have a single node to
>> represent a single GPIO controller, which just happens to internally
>> support a bunch of register arrays.
>
> Yes I agree, let's not go back to numbering anything except within the
> a single instance. If anything, we can put the gpio number into comments.
>

 From a board point a view, I consider this macro as being easier to use,
than having to perform the necessary arithmetic to get the bank + offset
for each GPIO when converting existing boards or developing new ones.

But I also agree with you, and I was sad not to find a more elegant
way. Maybe someone with better preprocessor skills could come up with
a better solution?

Regards,

Florian