[PATCH v3 6/7] ARM: kirkwood: add gigabit ethernet and mvmdio device tree nodes

[Sebastian Hesselbarth]

On 05/20/2013 11:27 PM, Simon Baatz wrote:
> Hi Sebastian,
>
> On Mon, May 06, 2013 at 05:33:39PM +0200, Sebastian Hesselbarth wrote:
>> This patch adds mv643xx_eth and mvmdio device tree nodes for DT enabled
>> Kirkwood boards. Phy nodes are also added with reg property set on a
>> per-board basis.
> ...
>> diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi
>> index fada7e6..c01a273 100644
>> --- a/arch/arm/boot/dts/kirkwood.dtsi
>> +++ b/arch/arm/boot/dts/kirkwood.dtsi
>> @@ -202,5 +202,57 @@
>>   			clocks =<&gate_clk 4>;
>>   			status = "disabled";
>>   		};
>> +
>> +		mdio: mdio-bus at 72004 {
>> +			compatible = "marvell,orion-mdio";
>> +			reg =<0x72004 0x84>;
>> +			interrupts =<11>;
>
> Shouldn't this be 46?

Yes, mdio is using GbE0Err interrupt and that is 14 on IRQ HIGH CAUSE.
I was misled by 11 on IRQ LOW CAUSE.

Sebastian