[RFC PATCH] CLK: Allow parent clock and rate to be configured in DT.

Martin Fuzzey mfuzzey at parkeon.com
Mon Mar 25 22:07:51 EST 2013


Hi Sascha,

thanks for the comments.

[corrected Mike's email address - I originally sent it to the old one]

On 25/03/13 11:17, Sascha Hauer wrote:
> On Tue, Mar 19, 2013 at 06:09:33PM +0100, Martin Fuzzey wrote:
>> Even on platforms where the entire clock tree is not represented in the DT
>> it can still be useful to allow parents and rates to be set from the DT.
>>
>> An example of such a case is when a multiplexable clock output from a SOC
>> is used to supply external chips (eg an audio codec connected to the i.MX53
>> cko1 pin).
>>
>> The cko1 pin can output various internal clock signals but, in
>> order to obtain a suitable frequency for the codec, an appropriate parent must
>> be selected.
>>
>> Another example is setting root clock dividers.
>>
>> This is board specific rather than device driver or platform clock framework
>> specific information and thus would be better in the DT.
> I see what the patch does and that it could be very useful, but there's
> a problem: The devicetree is for hardware *description*, not
> *configuration*.
>
>> +For example:
>> +	clock-configuration {
>> +		compatible = "clock-configuration";
>> +		clko1 {
>> +			clocks = <&clks 160>; /* cko1_sel */
>> +			parent = <&clks 114>; /* pll3_sw */
>> +		};
>> +
>> +		esdhca {
>> +			clocks = <&clks 102>; /* esdhc_a_podf */
>> +			clock-frequency = <200000000>;
>> +		};
> This example shows this. For some reason we adjust the esdhc frequency
> to 200MHz in the code currently, but this is because it matches our
> current usecase. Once you move this into devicetree, we can't change
> this anymore in the kernel, even if we find a much better way to adjust
> the frequency in the future (i.e. smaller values might be good for power
> savings, higher values might increase performance, we even might
> dynamically change this frequency).
>
Yes but the problem is that the rates are currently set in 
clk-imx51-53.c which should be generic
to all such platforms whereas, as you point out, there may well be valid 
reasons to choose
different values depending on the board design and / or intended 
application.

The cko case is even worse - due to a board design decision that clock 
needs to have
a frequency suitable for supplying some external chip. We don't want 
board specific code in
the platform clock code and we're trying to get away from board files...

> So no, this shouldn't be in the devicetree, even though it's very
> tempting to do so.
>
> I wonder when someone comes up with a 'configtree' where we could put in
> such stuff.
I don't understand why we need a seperate tree for this why can't just
a subtree of the DT be used?

After all the DT already contains "configuration" nodes such as "chosen".

Indeed Documentation/devicetree/usage-model.txt  says:
     "The chosen node may also optionally contain an arbitrary number of
     additional properties for platform-specific configuration data."

So what stops us simply placing the clock-configuration node above under 
chosen? (which already works - just tested it)

If the issue is that hardware vendors should be able to supply a DT 
without knowing
the configuration parameters couldn't that be resolved by letting the 
bootloader
merge DT subtrees this would give us "configtree" without adding more 
code to
the kernel to handle it.

Regards,

Martin



More information about the devicetree-discuss mailing list