[PATCH V2 0/8] ARM: OMAP3+: support cpufreq-cpu0 for device tree boot
Nishanth Menon
nm at ti.com
Wed Mar 20 04:53:02 EST 2013
Hi,
The following version 2 of the series arose from trying to use BeagleBoard-XM
(OMAP3 variant) for doing CPU DVFS using cpufreq-cpu0. This series enables the
generic cpufreq-cpu0 driver to be used in device tree enabled boot while
maintaining support of the legacy omap-cpufreq driver when used in non device
tree enabled boot.
However, in order to enable complete SoC entitlement for OMAP platforms, with
this series, key features are still pending on device tree adaptation for OMAP:
A) clock framework data transition to DT - this should happen soon, so this
series hacks the clock node for the time being as suggested in review of
original series[1].
B) On processors that use voltage controller, voltage processor (VC/VP hardware
loop using I2C_SR path) - we have started work on transitioning them to
regulator framework driven by DT.
C) Adaptive Body Bias and SmartReflex AVS conversion to DT.
As a result of these pending features:
- OMAP4 TWL6030 and TPS62361 which set voltage ONLY over I2C_SR have no
regulators associated at the moment - fortunately, we boot at highest voltage,
so things still work.
- Missing ABB and AVS implies that for few of the SoCs (3630, OMAP4), I have
not added those OPPs in DT yet - this also needs alignment with iMX, AM series
pending work, where certain OPPs need enabling based on efuse programmed
bit sequences - since it is an add-on work, it is not addressed here.
Note: At this point in time, we do not have DT entries for clock on OMAP
platforms. Common Clock Framework(CCF) could also control regulators[2].
Once these conversions are complete, there will be minimal cleanup work to
switch to the new data structure changes.
Key benefit of the series is to allow all relevant TI platforms now to use a
single cpufreq driver and equivalent frameworks in addition be part of the
transition to device tree.
NOTE: As a result of this series:
1. omap-cpufreq will be used only in non device tree boot scenario. we should
delete this driver once the 100% DT conversion is complete.
2. Generic cpufreq-cpu0 will be used only in device tree boot scenario.
boot systems.
Key changes in version 2:
- series now rebased on Device tree patches queued for OMAP 3.10
- cpufreq-cpu0 and omap_cpufreq will co-exist and used depending on
usage of device tree.
- minor wording, cleanups for the same.
- omap3.dtsi and omap4.dtsi now become common dtsi which is used by
omap34xx.dtsi, omap36xx.dtsi, omap443x.dtsi, omap4460.dtsi as needed.
version 1 of the series:
http://marc.info/?t=136329485400005&r=1&w=2
available at:
https://github.com/nmenon/linux-2.6-playground/commits/push/cpufreq-cpu0-omap-all-v1
[1] Original discussion thread which triggered this series:
http://marc.info/?l=linux-pm&m=136304313700602&w=2
https://patchwork.kernel.org/patch/2251841/
https://patchwork.kernel.org/patch/2251851/
[2] CCF DVFS patches:
https://patchwork.kernel.org/patch/2195431/
https://patchwork.kernel.org/patch/2195421/
https://patchwork.kernel.org/patch/2195451/
https://patchwork.kernel.org/patch/2195441/
https://patchwork.kernel.org/patch/2195461/
Version 2 is now based on for-3.10/dts branch from Benoit:
http://git.kernel.org/cgit/linux/kernel/git/bcousson/linux-omap-dt.git/log/?h=for_3.10/dts
44fab7a ARM: dts: omap3-devkit8000: Add NAND DT node
Version 2 is also available at:
https://github.com/nmenon/linux-2.6-playground/commits/push/cpufreq-cpu0-omap-all-v2
git link: git://github.com/nmenon/linux-2.6-playground.git
branch: cpufreq-cpu0-omap-all-v2
Test coverage:
test script: http://pastebin.com/zrr8ptge
Platforms verified:
beaglebone(rev A6a) - AM33xx compatible - http://pastebin.com/PUx5h6Jy
beagleboard (rev C1D) - OMAP3430 compatible - http://pastebin.com/SycCinFb (DT) http://pastebin.com/qwJHw9Ev (no DT)
omap3-beagle-xm -OMAP3630 compatible - http://pastebin.com/tVEXeVZC
Pandaboard -(OMAP4430 ES2.2) verified with omapconf - http://pastebin.com/cAtytfW0
Pandaboard-ES -(OMAP4460 ES1.1) verified with omapconf - http://pastebin.com/3EymNTMp
Nishanth Menon (8):
ARM: dts: OMAP34xx/35xx: Add CPU OPP table
ARM: dts: OMAP36xx: Add CPU OPP table
ARM: dts: OMAP3: use twl4030 vdd1 regulator for CPU
ARM: dts: OMAP443x: Add CPU OPP table
ARM: dts: omap4-panda: move generic sections to panda-common
ARM: dts: OMAP4460: Add CPU OPP table
ARM: OMAP3+: use cpu0-cpufreq driver in device tree supported boot
cpufreq: OMAP: donot allow to be used with device tree
arch/arm/boot/dts/am3517-evm.dts | 2 +-
arch/arm/boot/dts/am3517_mt_ventoux.dts | 2 +-
arch/arm/boot/dts/omap3-beagle-xm.dts | 6 +
arch/arm/boot/dts/omap3-beagle.dts | 8 +-
arch/arm/boot/dts/omap3-devkit8000.dts | 2 +-
arch/arm/boot/dts/omap3-evm.dts | 8 +-
arch/arm/boot/dts/omap3-igep.dtsi | 2 +-
arch/arm/boot/dts/omap3-overo.dtsi | 2 +-
arch/arm/boot/dts/omap3430-sdp.dts | 2 +-
arch/arm/boot/dts/omap34xx.dtsi | 28 ++++
arch/arm/boot/dts/omap36xx.dtsi | 13 ++
arch/arm/boot/dts/omap4-panda-a4.dts | 5 +-
arch/arm/boot/dts/omap4-panda-common.dtsi | 251 +++++++++++++++++++++++++++++
arch/arm/boot/dts/omap4-panda-es.dts | 3 +-
arch/arm/boot/dts/omap4-panda.dts | 247 +---------------------------
arch/arm/boot/dts/omap4-sdp.dts | 2 +-
arch/arm/boot/dts/omap4-var-som.dts | 2 +-
arch/arm/boot/dts/omap443x.dtsi | 27 ++++
arch/arm/boot/dts/omap4460.dtsi | 14 ++
arch/arm/boot/dts/twl4030.dtsi | 6 +
arch/arm/mach-omap2/board-generic.c | 5 +
arch/arm/mach-omap2/cclock33xx_data.c | 2 +-
arch/arm/mach-omap2/cclock3xxx_data.c | 3 +-
arch/arm/mach-omap2/cclock44xx_data.c | 3 +-
drivers/cpufreq/omap-cpufreq.c | 14 ++
25 files changed, 399 insertions(+), 260 deletions(-)
create mode 100644 arch/arm/boot/dts/omap34xx.dtsi
create mode 100644 arch/arm/boot/dts/omap4-panda-common.dtsi
create mode 100644 arch/arm/boot/dts/omap443x.dtsi
vmlinux size change information (omap2plus_defconfig + CPUFREQ enabled):
add/remove: 0/0 grow/shrink: 5/0 up/down: 208/0 (208)
function old new delta
omap_cpu_init 360 472 +112
omap_generic_init 96 140 +44
omap44xx_clks 5832 5856 +24
omap3xxx_clks 6720 6744 +24
omap3xxx_clk_init 1072 1076 +4
non-zero DTB size deltas(bytes):
old new delta filename
10671 10898 +227 omap3-beagle-xm.dtb
9947 10190 +243 omap3-beagle.dtb
11399 11582 +183 omap3-devkit8000.dtb
9731 9974 +243 omap3-evm.dtb
10958 11141 +183 omap3-igep0020.dtb
10906 11089 +183 omap3-igep0030.dtb
10255 10438 +183 omap3-tobi.dtb
11361 11544 +183 omap3430-sdp.dtb
16270 16361 +91 omap4-panda-a4.dtb
16326 16409 +83 omap4-panda-es.dtb
16270 16361 +91 omap4-panda.dtb
19379 19470 +91 omap4-sdp.dtb
12943 13034 +91 omap4-var-som.dtb
Cc: Kevin Hilman <khilman at deeprootsystems.com>
Cc: Jon Hunter <jon-hunter at ti.com>
Cc: "Benoît Cousson" <b-cousson at ti.com>
Cc: Santosh Shilimkar <santosh.shilimkar at ti.com>
Cc: Shawn Guo <shawn.guo at linaro.org>
Cc: Keerthy <j-keerthy at ti.com>
Cc: linux-omap at vger.kernel.org
Cc: devicetree-discuss at lists.ozlabs.org
Cc: linux-arm-kernel at lists.infradead.org
Cc: cpufreq at vger.kernel.org
Cc: linux-pm at vger.kernel.org
Regards,
Nishanth Menon
--
1.7.9.5
More information about the devicetree-discuss
mailing list