[PATCH V2 11/17] ARM: OMAP2+: Add device-tree support for NOR flash
Javier Martinez Canillas
javier at dowhile0.org
Sat Mar 9 14:11:58 EST 2013
On Fri, Mar 8, 2013 at 5:58 PM, Jon Hunter <jon-hunter at ti.com> wrote:
> NOR flash is not currently supported when booting with device-tree
> on OMAP2+ devices. Add support to detect and configure NOR devices
> when booting with device-tree.
>
> Add documentation for the TI GPMC NOR binding.
>
> Signed-off-by: Jon Hunter <jon-hunter at ti.com>
> ---
> Documentation/devicetree/bindings/mtd/gpmc-nor.txt | 98 +++++++++++++++++
> arch/arm/mach-omap2/gpmc.c | 113 ++++++++++++++++++++
> 2 files changed, 211 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/mtd/gpmc-nor.txt
>
> diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nor.txt b/Documentation/devicetree/bindings/mtd/gpmc-nor.txt
> new file mode 100644
> index 0000000..8c638fc
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mtd/gpmc-nor.txt
> @@ -0,0 +1,98 @@
> +Device tree bindings for NOR flash connect to TI GPMC
> +
> +NOR flash connected to the TI GPMC (found on OMAP boards) are represented as
> +child nodes of the GPMC controller with a name of "nor".
> +
> +All timing relevant properties as well as generic GPMC child properties are
> +explained in a separate documents. Please refer to
> +Documentation/devicetree/bindings/bus/ti-gpmc.txt
> +
> +Required properties:
> +- bank-width: Width of NOR flash in bytes. GPMC supports 8-bit and
> + 16-bit devices and so must be either 1 or 2 bytes.
> +- compatible: Documentation/devicetree/bindings/mtd/mtd-physmap.txt
> +- gpmc,cs-on: Chip-select assertion time
> +- gpmc,cs-rd-off: Chip-select de-assertion time for reads
> +- gpmc,cs-wr-off: Chip-select de-assertion time for writes
> +- gpmc,oe-on: Output-enable assertion time
> +- gpmc,oe-off Output-enable de-assertion time
> +- gpmc,we-on: Write-enable assertion time
> +- gpmc,we-off: Write-enable de-assertion time
> +- gpmc,access: Start cycle to first data capture (read access)
> +- gpmc,rd-cycle: Total read cycle time
> +- gpmc,wr-cycle: Total write cycle time
> +- linux,mtd-name: Documentation/devicetree/bindings/mtd/mtd-physmap.txt
> +- reg: Chip-select, base address (relative to chip-select)
> + and size of NOR flash. Note that base address will be
> + typically 0 as this is the start of the chip-select.
> +
> +Optional properties:
> +- gpmc,XXX Additional GPMC timings and settings parameters. See
> + Documentation/devicetree/bindings/bus/ti-gpmc.txt
> +
> +Optional properties for partiton table parsing:
> +- #address-cells: should be set to 1
> +- #size-cells: should be set to 1
> +
> +Example:
> +
> +gpmc: gpmc at 6e000000 {
> + compatible = "ti,omap3430-gpmc", "simple-bus";
> + ti,hwmods = "gpmc";
> + reg = <0x6e000000 0x1000>;
> + interrupts = <20>;
> + gpmc,num-cs = <8>;
> + gpmc,num-waitpins = <4>;
> + #address-cells = <2>;
> + #size-cells = <1>;
> +
> + ranges = <0 0 0x10000000 0x08000000>;
> +
> + nor at 0,0 {
> + compatible = "cfi-flash";
> + linux,mtd-name= "intel,pf48f6000m0y1be";
> + #address-cells = <1>;
> + #size-cells = <1>;
> + reg = <0 0 0x08000000>;
> + bank-width = <2>;
> +
> + gpmc,mux-add-data;
> + gpmc,cs-on = <0>;
> + gpmc,cs-rd-off = <186>;
> + gpmc,cs-wr-off = <186>;
> + gpmc,adv-on = <12>;
> + gpmc,adv-rd-off = <48>;
> + gpmc,adv-wr-off = <48>;
> + gpmc,oe-on = <54>;
> + gpmc,oe-off = <168>;
> + gpmc,we-on = <54>;
> + gpmc,we-off = <168>;
> + gpmc,rd-cycle = <186>;
> + gpmc,wr-cycle = <186>;
> + gpmc,access = <114>;
> + gpmc,page-burst-access = <6>;
> + gpmc,bus-turnaround = <12>;
> + gpmc,cycle2cycle-delay = <18>;
> + gpmc,wr-data-mux-bus = <90>;
> + gpmc,wr-access = <186>;
> + gpmc,cycle2cycle-samecsen;
> + gpmc,cycle2cycle-diffcsen;
> +
> + partition at 0 {
> + label = "bootloader-nor";
> + reg = <0 0x40000>;
> + };
> + partition at 0x40000 {
> + label = "params-nor";
> + reg = <0x40000 0x40000>;
> + };
> + partition at 0x80000 {
> + label = "kernel-nor";
> + reg = <0x80000 0x200000>;
> + };
> + partition at 0x280000 {
> + label = "filesystem-nor";
> + reg = <0x240000 0x7d80000>;
> + };
> + };
> +};
> diff --git a/arch/arm/mach-omap2/gpmc.c b/arch/arm/mach-omap2/gpmc.c
> index 80808ad..05ca0af 100644
> --- a/arch/arm/mach-omap2/gpmc.c
> +++ b/arch/arm/mach-omap2/gpmc.c
> @@ -26,6 +26,7 @@
> #include <linux/interrupt.h>
> #include <linux/platform_device.h>
> #include <linux/of.h>
> +#include <linux/of_address.h>
> #include <linux/of_mtd.h>
> #include <linux/of_device.h>
> #include <linux/mtd/nand.h>
> @@ -499,6 +500,37 @@ static int gpmc_cs_delete_mem(int cs)
> return r;
> }
>
> +/**
> + * gpmc_cs_remap - remaps a chip-select physical base address
> + * @cs: chip-select to remap
> + * @base: physical base address to re-map chip-select to
> + *
> + * Re-maps a chip-select to a new physical base address specified by
> + * "base". Returns 0 on success and appropriate negative error code
> + * on failure.
> + */
> +static int gpmc_cs_remap(int cs, u32 base)
> +{
> + int ret;
> + u32 old_base, size;
> +
> + if (cs > GPMC_CS_NUM)
> + return -ENODEV;
> + gpmc_cs_get_memconf(cs, &old_base, &size);
> + if (base == old_base)
> + return 0;
> + gpmc_cs_disable_mem(cs);
> + ret = gpmc_cs_delete_mem(cs);
> + if (IS_ERR_VALUE(ret))
> + return ret;
> + ret = gpmc_cs_insert_mem(cs, base, size);
> + if (IS_ERR_VALUE(ret))
> + return ret;
> + gpmc_cs_enable_mem(cs, base, size);
> +
> + return 0;
> +}
> +
> int gpmc_cs_request(int cs, unsigned long size, unsigned long *base)
> {
> struct resource *res = &gpmc_cs_mem[cs];
> @@ -1398,6 +1430,78 @@ static int gpmc_probe_onenand_child(struct platform_device *pdev,
> }
> #endif
>
> +/**
> + * gpmc_probe_nor_child - configures the gpmc for a nor device
> + * @pdev: pointer to gpmc platform device
> + * @child: pointer to device-tree node for nor device
> + *
> + * Allocates and configures a GPMC chip-select for a NOR flash device.
> + * Returns 0 on success and appropriate negative error code on failure.
> + */
> +static int gpmc_probe_nor_child(struct platform_device *pdev,
> + struct device_node *child)
> +{
> + struct gpmc_settings gpmc_s;
> + struct gpmc_timings gpmc_t;
> + struct resource res;
> + unsigned long base;
> + int ret, cs;
> +
> + if (of_property_read_u32(child, "reg", &cs) < 0) {
> + dev_err(&pdev->dev, "%s has no 'reg' property\n",
> + child->full_name);
> + return -ENODEV;
> + }
> +
> + if (of_address_to_resource(child, 0, &res)) {
> + dev_err(&pdev->dev, "%s has malformed 'reg' property\n",
> + child->full_name);
> + return -ENODEV;
> + }
> +
> + ret = gpmc_cs_request(cs, resource_size(&res), &base);
> + if (IS_ERR_VALUE(ret)) {
> + dev_err(&pdev->dev, "cannot request GPMC CS %d\n", cs);
> + return ret;
> + }
> +
> + /*
> + * FIXME: gpmc_cs_request() will map the CS to an arbitary
> + * location in the gpmc address space. When booting with
> + * device-tree we want the NOR flash to be mapped to the
> + * location specified in the device-tree blob. So remap the
> + * CS to this location. Once DT migration is complete should
> + * just make gpmc_cs_request() map a specific address.
> + */
> + ret = gpmc_cs_remap(cs, res.start);
> + if (IS_ERR_VALUE(ret)) {
> + dev_err(&pdev->dev, "cannot remap GPMC CS %d to 0x%x\n",
> + cs, res.start);
> + goto err;
> + }
> +
> + gpmc_read_settings_dt(child, &gpmc_s);
> +
> + ret = of_property_read_u32(child, "bank-width", &gpmc_s.device_width);
> + if (IS_ERR_VALUE(ret))
> + goto err;
> +
> + ret = gpmc_cs_program_settings(cs, &gpmc_s);
> + if (IS_ERR_VALUE(ret))
> + goto err;
> +
> + gpmc_read_timings_dt(child, &gpmc_t);
> + gpmc_cs_set_timings(cs, &gpmc_t);
> +
> + of_platform_device_create(child, NULL, &pdev->dev);
> +
Hi Jon,
of_platform_device_create() can fail afaik so I think you could add a
check and return -ENODEV if it fails.
I guess it can be a follow-up patch though.
Best regards,
Javier
More information about the devicetree-discuss
mailing list