[PATCH 3/5] gpio/omap: Add DT support to GPIO driver

Jon Hunter jon-hunter at ti.com
Fri Mar 8 10:14:09 EST 2013


On 03/02/2013 02:05 PM, Grant Likely wrote:
> On Tue, 26 Feb 2013 17:01:22 -0600, Jon Hunter <jon-hunter at ti.com> wrote:
>>
>> On 02/26/2013 04:44 PM, Stephen Warren wrote:
>>> On 02/26/2013 03:40 PM, Jon Hunter wrote:
>>>> On 02/26/2013 04:01 AM, Javier Martinez Canillas wrote:
>>>> Are you requesting the gpio anywhere? If not then this is not going to
>>>> work as-is. This was discussed fairly recently [1] and the conclusion
>>>> was that the gpio needs to be requested before we can use as an interrupt.
>>>
>>> That seems wrong; the GPIO/IRQ driver should handle this internally. The
>>> Ethernet driver shouldn't know/care whether the interrupt it's given is
>>> some form of dedicated interrupt or a GPIO-based interrupt, and even if
>>> it somehow did, there's no irq_to_gpio() any more, so the driver can't
>>> tell which GPIO ID it should request, unless it's given yet another
>>> property to represent this.
>>
>> I agree that ideally this should be handled internally. Did you read the
>> discussion on the thread that I referenced [1]? If you have any thoughts
>> we are open to ideas :-)
> 
> I'm on an airplane right now, but I agree 100% with Stephen. I'll try to
> remember to go read that thread and respond, but this falls firmly in
> the its-a-bug category for me.  :-)

Grant, did you have chance to review the thread [1]?

I am trying to figure out if we should just take the original patch
proposed in the thread (although Linus had some objections) or look at
alternative solutions such as adding a irq_chip request as Stephen
suggested.

Cheers
Jon

[1] comments.gmane.org/gmane.linux.ports.arm.omap/92192


More information about the devicetree-discuss mailing list