[PATCH V2] cpufreq: ARM big LITTLE: Add generic cpufreq driver and its DT glue

Guennadi Liakhovetski g.liakhovetski at gmx.de
Fri Mar 8 08:56:54 EST 2013


Hi Viresh

On Fri, 8 Mar 2013, Viresh Kumar wrote:

> big LITTLE is ARM's new Architecture focussing power/performance needs of modern
> world. More information about big LITTLE can be found here:
> 
> http://www.arm.com/products/processors/technologies/biglittleprocessing.php
> http://lwn.net/Articles/481055/
> 
> In order to keep cpufreq support for all big LITTLE platforms simple/generic,
> this patch tries to add a generic cpufreq driver layer for all big LITTLE
> platforms.

I like generic drivers :) cpufreq-cpu0 is yet another such generic 
(cpufreq) driver. Now, comparing the functionality of the two:

[snip]

> +/* Set clock frequency */
> +static int bL_cpufreq_set_target(struct cpufreq_policy *policy,
> +		unsigned int target_freq, unsigned int relation)
> +{
> +	struct cpufreq_freqs freqs;
> +	u32 cpu = policy->cpu, freq_tab_idx, cur_cluster;
> +	int ret = 0;
> +
> +	cur_cluster = cpu_to_cluster(policy->cpu);
> +
> +	freqs.old = bL_cpufreq_get(policy->cpu);
> +
> +	/* Determine valid target frequency using freq_table */
> +	cpufreq_frequency_table_target(policy, freq_table[cur_cluster],
> +			target_freq, relation, &freq_tab_idx);
> +	freqs.new = freq_table[cur_cluster][freq_tab_idx].frequency;
> +
> +	freqs.cpu = policy->cpu;
> +
> +	pr_debug("%s: cpu: %d, cluster: %d, oldfreq: %d, target freq: %d, new freq: %d\n",
> +			__func__, cpu, cur_cluster, freqs.old, target_freq,
> +			freqs.new);
> +
> +	if (freqs.old == freqs.new)
> +		return 0;
> +
> +	for_each_cpu(freqs.cpu, policy->cpus)
> +		cpufreq_notify_transition(&freqs, CPUFREQ_PRECHANGE);
> +
> +	ret = clk_set_rate(clk[cur_cluster], freqs.new * 1000);

we see, that this driver "only" switches CPU clock frequencies. Whereas 
the cpufreq-cpu0 driver also manipulates a regulator (if available) 
directly. I understand, power-saving is also an important consideration 
for big.LITTLE systems. So, I presume, you plan to implement voltage 
switching in cpufreq notifiers? Now, my question is: is this (notifier) 
actually the preferred method and the cpufreq-cpu0 driver is doing it 
"wrongly?"

Thanks
Guennadi
---
Guennadi Liakhovetski, Ph.D.
Freelance Open-Source Software Developer
http://www.open-technology.de/


More information about the devicetree-discuss mailing list