[PATCH 3/4] pinctrl: remove slew-rate parameter from tz1090

[James Hogan]

On 25/06/13 14:22, Linus Walleij wrote:
> Can't we just try to come up with a patch that nails down the meaning of
> slew rate in some meaningful manner then?
> 
> So according to:
> http://en.wikipedia.org/wiki/Slew_rate
> a proper expression for slew rate would be dV/dt i.e.
> something like microvolts per microsecond (which then just
> becomes volts/second).
> 
> What we need to figure out is what range will be applicable within
> reasonable doubt for current scenarios and the next few years.
> 
> What are your datasheets specifying here, and what would be
> a proper measure?

My datasheet says:

0: slow (half frequency)
1: fast

I just got a reply back from a hardware engineer, who said that the
relationship with the actual volts/usec will depend on both the drive
strength and the load on the pad, and that a definite answer probably
requires running a simulation.

Cheers
James