[PATCH 5/6] ARM: dts: imx27 cpufreq-cpu0 frequencies

Markus Pargmann mpa at pengutronix.de
Fri Jun 21 00:50:14 EST 2013


Set operating-points for imx27. There is no regulator support, so the
voltages are 0. The frequencies should be the same for all imx27 boards,
so it is defined here and can be overwritten if necessary.

Signed-off-by: Markus Pargmann <mpa at pengutronix.de>
---
 arch/arm/boot/dts/imx27.dtsi | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/arch/arm/boot/dts/imx27.dtsi b/arch/arm/boot/dts/imx27.dtsi
index e883e77..3ebd98a 100644
--- a/arch/arm/boot/dts/imx27.dtsi
+++ b/arch/arm/boot/dts/imx27.dtsi
@@ -47,6 +47,25 @@
 		};
 	};
 
+	cpus {
+		#size-cells = <0>;
+		#address-cells = <1>;
+
+		cpu at 0 {
+			device_type = "cpu";
+			compatible = "fsl,imx27", "arm,arm926ejs";
+			reg = <0>;
+			operating-points = <
+				/* kHz  uV (No regulator support) */
+				133000  0
+				399000  0
+			>;
+			clock-latency = <61036>; /* two CLK32 periods */
+			clocks = <&clks 18>;
+			clock-names = "cpu";
+		};
+	};
+
 	soc {
 		#address-cells = <1>;
 		#size-cells = <1>;
-- 
1.8.2.1



More information about the devicetree-discuss mailing list