[PATCH] ARM: dts: add dtsi for palmas

[Benoit Cousson]

Hi Keerthy,

On 06/10/2013 06:03 AM, J, KEERTHY wrote:
> Hi Stephen,
> 
> Thanks for the review comments.
> 
> ________________________________________
> From: Stephen Warren [swarren at wwwdotorg.org]
> Sent: Saturday, June 08, 2013 1:26 AM
> To: J, KEERTHY
> Cc: Cousson, Benoit; devicetree-discuss at lists.ozlabs.org; linux-omap at vger.kernel.org; linux-kernel at vger.kernel.org; ldewangan at nvidia.com; grant.likely at secretlab.ca; swarren at nvidia.com; sameo at linux.intel.com; gg at slimlogic.co.uk; lee.jones at linaro.org
> Subject: Re: [PATCH] ARM: dts: add dtsi for palmas
> 
> On 06/07/2013 05:28 AM, J Keerthy wrote:
>> Adds palmas mfd and palmas regulator nodes. This is
>> based on the patch series:
>>
>> http://www.mail-archive.com/linux-omap@vger.kernel.org/msg89957.html
>>
>> The device tree nodes are based on:
>> https://lkml.org/lkml/2013/6/6/25
> 
>> diff --git a/arch/arm/boot/dts/palmas.dtsi b/arch/arm/boot/dts/palmas.dtsi
> 
>> +&palmas {
> 
> Hmmm. That (i.e. requiring the board file to declare the node, then
> setting up all the content by later including this file) is an
> interesting approach. I guess it's reasonable. The one issue is that it
> makes it a little harder for the board file to override any of the
> properties in this file., although it certainly is possible by including
> those overrides after the include.
> 
> Irrespective of that, some comments on this:
> 
>> +     palmas_pmic {
> 
>> +             ti,ldo6-vibrator;
> 
> For example, what if the board doesn't want to have the property set?
> 
>> +
>> +             regulators {
>> +                     smps123_reg: smps123 {
>> +                             regulator-name = "smps123";
>> +                             regulator-min-microvolt = < 600000>;
>> +                             regulator-max-microvolt = <1500000>;
> 
> Or what if the board wants to limit the voltage range of this regulator
> due to what it's used for on the board.
> 
>> +                             regulator-always-on;
>> +                             regulator-boot-on;
> 
> And those two properties are almost certainly board-specific policy.
> 
> Totally agree to all the above concerns. So can we have a custom .dtsi file
> for a board+pmic combination? Or have only the required properties over ridden
> in the board file?

Yes, you can do that potentially if most OMAP5 boards will reuse the
same kind of settings. Kevin has just done that for OMAP3 + twl4030.

In this case, since we do have only one board, I'm not sure it worth the
effort.

Regards,
Benoit