[PATCH v3 1/4] drivers: usb: phy: add a new driver for usb part of control module

[kishon]

On Friday 25 January 2013 02:15 PM, Felipe Balbi wrote:
> hi,
>
> On Fri, Jan 25, 2013 at 02:12:41PM +0530, kishon wrote:
>> On Friday 25 January 2013 01:18 PM, Felipe Balbi wrote:
>>> On Thu, Jan 24, 2013 at 09:32:46PM -0800, Stephen Warren wrote:
>>>> On 01/24/2013 06:19 PM, Kishon Vijay Abraham I wrote:
>>>>> Added a new driver for the usb part of control module. This has an API
>>>>> to power on the USB2 phy and an API to write to the mailbox depending on
>>>>> whether MUSB has to act in host mode or in device mode.
>>>>>
>>>>> Writing to control module registers for doing the above task which was
>>>>> previously done in omap glue and in omap-usb2 phy will be removed.
>>>>
>>>>> diff --git a/Documentation/devicetree/bindings/usb/usb-phy.txt b/Documentation/devicetree/bindings/usb/usb-phy.txt
>>>>
>>>> This file seems to be specific to the TI USB PHYs, not all USB PHYs;
>>>> shouldn't it be renamed ti-usb-phy.txt, or even better renamed to match
>>>> the compatible value it documents, giving ti,omap-usb2.txt?
>>>
>>> could be, but that can be done as a separate patch. It's not part of
>>> $SUBJECT.
>>>
>>>>>   add the address of control module dev conf register until a driver for
>>>>>   control module is added
>>>>>
>>>>> +Optional properties:
>>>>> + - ctrl_module : phandle of the control module used by PHY driver to power on
>>>>> +   the PHY.
>>>>
>>>> DT property names generally use - not _ as the word separator.
>>>
>>> fair enough, Kishon, can you fix this up ?
>>
>> Sure. Will post a patch..
>
> Great, notice that I've already applied some of your patches to my tree.
>
Cool. Thanks :-)

Regards
Kishon