[PATCH v4 0/3] mtd: nand: OMAP: ELM error correction support for BCH ecc
Philip Avinash
avinashphilip at ti.com
Fri Jan 4 18:56:48 EST 2013
Support to use ELM as BCH 4 & 8 bit error correction module. Also performance
enhancement by adding single shot read_page and write_page functions for the
nand flashes with page size less than 4 KB.
ELM module can be used to correct errors reported by BCH 4, 8 & 16 bit
ECC scheme. For now only 4 & 8 bit support is added.
BCH 4 & 8 bit error detection support is already available in mainline
kernel and works with software error correction.
This series is based on linux 3.8-rc2 and tested with [1].
Also this patch series depend on [1] for NAND flash device
tree data and gpmc nand device tree binding documentation updates.
1. [PATCH v7 0/5] OMAP GPMC DT bindings
http://www.spinics.net/lists/linux-omap/msg83505.html
Tested on am335x-evm for BCH 4 and 8 bit error correction.
Changes since v1:
- Erased page is identified by checking byte [13/7] in read
ecc. To filter out bit flips in OOB area, check 0 bits in
the byte greater than 4.
- GPMC ecc engine configuration moves to omap2.c NAND driver.
Changes since v2:
- Added runtime detection of elm module, instead of depending
on platform data.
- Added bit flip correction in OOB ecc data if bit flip happen
OOB data.
Changes since v3:
- Availability and usability of ELM module is detected from device
tree nodes by checking availability of ELM node in device tree.
Philip Avinash (3):
mtd: nand: omap2: Update nerrors using ecc.strength
mtd: devices: elm: Add support for ELM error correction
mtd: nand: omap2: Support for hardware BCH error correction.
Documentation/devicetree/bindings/mtd/elm.txt | 16 +
.../devicetree/bindings/mtd/gpmc-nand.txt | 4 +
drivers/mtd/devices/Makefile | 4 +-
drivers/mtd/devices/elm.c | 405 ++++++++++++++
drivers/mtd/nand/omap2.c | 583 ++++++++++++++++++--
include/linux/platform_data/elm.h | 54 ++
6 files changed, 1023 insertions(+), 43 deletions(-)
create mode 100644 Documentation/devicetree/bindings/mtd/elm.txt
create mode 100644 drivers/mtd/devices/elm.c
create mode 100644 include/linux/platform_data/elm.h
--
1.7.9.5
More information about the devicetree-discuss
mailing list