[PATCH 4/4] ARM: tegra: Set SCU base address dynamically from DT

Stephen Warren swarren at wwwdotorg.org
Thu Jan 3 06:02:53 EST 2013

Previous message: [PATCH V7] kbuild: create a rule to run the pre-processor on *.dts files
Next message: [PATCH 4/4] ARM: tegra: Set SCU base address dynamically from DT
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

On 12/16/2012 11:18 PM, Hiroshi Doyu wrote:
> Set Snoop Control Unit(SCU) register base address dynamically from DT.

Hiroshi, what's the status on this patch series? I think Rob had
comments/objections on patch 4; are you going to post an updated series,
or is this series replaced by patch 3 in your Tegra114 series?

Previous message: [PATCH V7] kbuild: create a rule to run the pre-processor on *.dts files
Next message: [PATCH 4/4] ARM: tegra: Set SCU base address dynamically from DT
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

More information about the devicetree-discuss mailing list