[PATCH v3 2/3] ARM: davinci: da850: add mmc DT entries

[Manjunathappa, Prakash]

Add DT entry for MMC. Also add entry for pinmux information.
Tested:
1) Without GPIO card detection and EDMA support as DT support for
   GPIO and EDMA are yet come.
2) By creating/deleting files and mounting/unmounting the partition.

Signed-off-by: Manjunathappa, Prakash <prakash.pm at ti.com>
Cc: linux-mmc at vger.kernel.org
Cc: linux-arm-kernel at lists.infradead.org
Cc: davinci-linux-open-source at linux.davincidsp.com
Cc: devicetree-discuss at lists.ozlabs.org
Cc: cjb at laptop.org
Cc: Sekhar Nori <nsekhar at ti.com>
---
Since v2:
Remove properties specifying for highspeed card capability.
Since v1:
Removed bitfields for specifying the device capabilty and accomodate
controller revision in compatible field.

 arch/arm/boot/dts/da850-evm.dts |    7 +++++++
 arch/arm/boot/dts/da850.dtsi    |   14 ++++++++++++++
 2 files changed, 21 insertions(+), 0 deletions(-)

diff --git a/arch/arm/boot/dts/da850-evm.dts b/arch/arm/boot/dts/da850-evm.dts
index f712fb6..78c8e54 100644
--- a/arch/arm/boot/dts/da850-evm.dts
+++ b/arch/arm/boot/dts/da850-evm.dts
@@ -39,6 +39,13 @@
 		wdt: wdt at 1c21000 {
 			status = "okay";
 		};
+		mmc0: mmc at 1c40000 {
+			max-frequency = <50000000>;
+			bus-width = <4>;
+			status = "okay";
+			pinctrl-names = "default";
+			pinctrl-0 = <&mmc0_pins>;
+		};
 	};
 	nand_cs3 at 62000000 {
 		status = "okay";
diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi
index 4b2262a..ebe7386 100644
--- a/arch/arm/boot/dts/da850.dtsi
+++ b/arch/arm/boot/dts/da850.dtsi
@@ -67,6 +67,15 @@
 					0x10 0x00002200 0x0000ff00
 				>;
 			};
+			mmc0_pins: pinmux_mmc_pins {
+				pinctrl-single,bits = <
+					/* MMCSD0_DAT[3] MMCSD0_DAT[2]
+					 * MMCSD0_DAT[1] MMCSD0_DAT[0]
+					 * MMCSD0_CMD    MMCSD0_CLK
+					 */
+					0x28 0x00222222  0x00ffffff
+				>;
+			};
 		};
 		serial0: serial at 1c42000 {
 			compatible = "ns16550a";
@@ -110,6 +119,11 @@
 		wdt: wdt at 1c21000 {
 			compatible = "ti,davinci-wdt";
 			reg = <0x21000 0x1000>;
+		};
+		mmc0: mmc at 1c40000 {
+			compatible = "ti,davinci-mmc-da830";
+			reg = <0x40000 0x1000>;
+			interrupts = <16>;
 			status = "disabled";
 		};
 	};
-- 
1.7.4.1