[RFC v2 5/6] media: s5p-csis: Adding Exynos5250 compatibility

[Sylwester Nawrocki]

On 04/24/2013 09:41 AM, Shaik Ameer Basha wrote:
> FIMC-IS firmware needs all the MIPI-CSIS interrupts to be enabled.
> This patch enables all those MIPI interrupts and adds the Exynos5
> compatible string.
> 
> Signed-off-by: Shaik Ameer Basha <shaik.ameer at samsung.com>
> ---
>  drivers/media/platform/exynos4-is/mipi-csis.c |    3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/media/platform/exynos4-is/mipi-csis.c b/drivers/media/platform/exynos4-is/mipi-csis.c
> index 8636bcd..51ad9b2 100644
> --- a/drivers/media/platform/exynos4-is/mipi-csis.c
> +++ b/drivers/media/platform/exynos4-is/mipi-csis.c
> @@ -66,7 +66,7 @@ MODULE_PARM_DESC(debug, "Debug level (0-2)");
>  
>  /* Interrupt mask */
>  #define S5PCSIS_INTMSK			0x10
> -#define S5PCSIS_INTMSK_EN_ALL		0xf000103f
> +#define S5PCSIS_INTMSK_EN_ALL		0xfc00103f

I'm a bit reluctant to apply this patch as is. These interrupts should not
be enabled if are not required. I'll try to make some patch to allow a media
device driver to enable/disable the frame start/end interrupts when needed.
But it would presumably be on top of this patch.

>  #define S5PCSIS_INTMSK_EVEN_BEFORE	(1 << 31)
>  #define S5PCSIS_INTMSK_EVEN_AFTER	(1 << 30)
>  #define S5PCSIS_INTMSK_ODD_BEFORE	(1 << 29)
> @@ -1003,6 +1003,7 @@ static const struct dev_pm_ops s5pcsis_pm_ops = {
>  static const struct of_device_id s5pcsis_of_match[] = {
>  	{ .compatible = "samsung,s5pv210-csis" },
>  	{ .compatible = "samsung,exynos4210-csis" },
> +	{ .compatible = "samsung,exynos5250-csis" },
>  	{ /* sentinel */ },
>  };

Regards,
Sylwester