[PATCH V4 10/18] ARM: OMAP2+: Add function to read GPMC settings from device-tree

[Grant Likely]

On Tue, 19 Mar 2013 11:35:48 -0500, Jon Hunter <jon-hunter at ti.com> wrote:
> Adds a function to read the various GPMC chip-select settings from
> device-tree and store them in the gpmc_settings structure.
> 
> Update the GPMC device-tree binding documentation to describe these
> options.
> 
> Signed-off-by: Jon Hunter <jon-hunter at ti.com>
> Tested-by: Ezequiel Garcia <ezequiel.garcia at free-electrons.com>
> ---
>  Documentation/devicetree/bindings/bus/ti-gpmc.txt |   23 ++++++++++++
>  arch/arm/mach-omap2/gpmc.c                        |   40 +++++++++++++++++++++
>  arch/arm/mach-omap2/gpmc.h                        |    2 ++
>  3 files changed, 65 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/bus/ti-gpmc.txt b/Documentation/devicetree/bindings/bus/ti-gpmc.txt
> index 5ddb2e9..6fde1cf 100644
> --- a/Documentation/devicetree/bindings/bus/ti-gpmc.txt
> +++ b/Documentation/devicetree/bindings/bus/ti-gpmc.txt
> @@ -65,6 +65,29 @@ The following are only applicable to OMAP3+ and AM335x:
>   - gpmc,wr-access
>   - gpmc,wr-data-mux-bus
>  
> +GPMC chip-select settings properties for child nodes. All are optional.
> +
> +- gpmc,burst-length	Page/burst length. Must be 4, 8 or 16.
> +- gpmc,burst-wrap	Enables wrap bursting
> +- gpmc,burst-read	Enables read page/burst mode
> +- gpmc,burst-write	Enables write page/burst mode
> +- gpmc,device-nand	Device is NAND
> +- gpmc,device-width	Total width of device(s) connected to a GPMC
> +			chip-select in bytes. The GPMC supports 8-bit
> +			and 16-bit devices and so this property must be
> +			1 or 2.

I would suggest specifying the actual number of bits. ie. 8 or 16. There is some
precidence for that already in DT bindings.

> +- gpmc,mux-add-data	Address and data multiplexing configuration.
> +			Valid values are 1 for address-address-data
> +			multiplexing mode and 2 for address-data
> +			multiplexing mode.
> +- gpmc,sync-read	Enables synchronous read. Defaults to asynchronous
> +			is this is not set.

'if'?

> +- gpmc,sync-write	Enables synchronous writes. Defaults to asynchronous
> +			is this is not set.
> +- gpmc,wait-pin		Wait-pin used by client. Must be less than
> +			"gpmc,num-waitpins".
> +- gpmc,wait-on-read	Enables wait monitoring on reads.
> +- gpmc,wait-on-write	Enables wait monitoring on writes.

Otherwise looks okay to me.

g.