[PATCH v7 2/3] arm/dts: AM33XX: Configure pinmuxs for user leds control on Bone
AnilKumar Ch
anilkumar at ti.com
Thu Sep 6 19:38:23 EST 2012
Adds GPIO pinctrl nodes to am3358_pinmux master node to control
user leds (USR0, USR1, USR2 and USR3) present on BeagleBone.
[koen at dominion.thruhere.net: led0, led1 suggested by koen]
Signed-off-by: AnilKumar Ch <anilkumar at ti.com>
---
arch/arm/boot/dts/am335x-bone.dts | 43 +++++++++++++++++++++++++++++++++++++
1 file changed, 43 insertions(+)
diff --git a/arch/arm/boot/dts/am335x-bone.dts b/arch/arm/boot/dts/am335x-bone.dts
index c634f87..b0a7409 100644
--- a/arch/arm/boot/dts/am335x-bone.dts
+++ b/arch/arm/boot/dts/am335x-bone.dts
@@ -18,11 +18,54 @@
reg = <0x80000000 0x10000000>; /* 256 MB */
};
+ am33xx_pinmux: pinmux at 44e10800 {
+ userled_pins: pinmux_userled_pins {
+ pinctrl-single,pins = <
+ 0x54 0x7 /* gpmc_a5.gpio1_21, OUTPUT | MODE7 */
+ 0x58 0x17 /* gpmc_a6.gpio1_22, OUTPUT_PULLUP | MODE7 */
+ 0x5c 0x7 /* gpmc_a7.gpio1_23, OUTPUT | MODE7 */
+ 0x60 0x17 /* gpmc_a8.gpio1_24, OUTPUT_PULLUP | MODE7 */
+ >;
+ };
+ };
+
ocp {
uart1: serial at 44e09000 {
status = "okay";
};
+ leds {
+ compatible = "gpio-leds";
+ pinctrl-names = "default";
+ pinctrl-0 = <&userled_pins>;
+
+ heartbeat {
+ label = "beaglebone:green:usr0";
+ gpios = <&gpio2 21 0>;
+ linux,default-trigger = "heartbeat";
+ default-state = "off";
+ };
+
+ mmc {
+ label = "beaglebone:green:usr1";
+ gpios = <&gpio2 22 0>;
+ linux,default-trigger = "mmc0";
+ default-state = "off";
+ };
+
+ led2 {
+ label = "beaglebone:green:usr2";
+ gpios = <&gpio2 23 0>;
+ default-state = "off";
+ };
+
+ led3 {
+ label = "beaglebone:green:usr3";
+ gpios = <&gpio2 24 0>;
+ default-state = "off";
+ };
+ };
+
i2c1: i2c at 44e0b000 {
status = "okay";
clock-frequency = <400000>;
--
1.7.9.5
More information about the devicetree-discuss
mailing list