[RFC PATCH] ARM: OMAP2+: omap-device: Do not overwrite resources allocated by OF layer

Hiremath, Vaibhav hvaibhav at ti.com
Sat Sep 1 01:36:00 EST 2012


On Fri, Aug 31, 2012 at 20:54:53, Cousson, Benoit wrote:
> Hi Vaibhav,
> 
> On 08/29/2012 11:48 AM, Vaibhav Hiremath wrote:
> > With the new devices (like, AM33XX and OMAP5) we now only support
> > DT boot mode of operation and now it is the time to start killing
> > slowly the dependency on hwmod, so with this patch, we are starting
> > with device resources.
> 
> Thanks for working on that.
> 
> > The idea here is implemented considering to both boot modes -
> >   - DT boot mode
> >     OF framework will construct the resource structure (currently
> >     does for MEM & IRQ resource) and we should respect/use these
> >     resources, killing hwmod dependency.
> >     If pdev->num_resources > 0, we assume that MEM & IRQ resources
> >     have been allocated by OF layer already (through DTB).
> > 
> >     Once DMA resource is available from OF layer, we should
> >     kill filling any resources from hwmod.
> 
> Yeap, I did a similar patch some months ago and decided to drop it
> because I was expected the DMA binding to be there and wanted to avoid
> adding more code that we are going to remove later.
> 
> The other potential issue is that when the binding will be there, we
> will have to update all the drivers and DTS first before being able to
> change the hwmod code from hwmod DMA to DTS DMA.
> I was thinking of something smoother that will check if DMA is in DTS
> and fall back to hwmod if not to avoid that.
> But again, I'm not sure it worth the effort.
> 
> >   - Non-DT boot mode
> >     Here, pdev->num_resources = 0, and we should get all the
> >     resources from hwmod (following existing steps)
> > 
> > Signed-off-by: Vaibhav Hiremath <hvaibhav at ti.com>
> > Cc: Benoit Cousson <b-cousson at ti.com>
> > Cc: Tony Lindgren <tony at atomide.com>
> > Cc: Paul Walmsley <paul at pwsan.com>
> > Cc: Kevin Hilman <khilman at ti.com>
> > ---
> > This patch is tested on BeagleBone and AM37xEVM.
> 
> I'll try to do more testing on Panda next week.
> 

Thanks a lot.

> > Why RFC?
> > Still we have function duplication omap_device_fill_resources() and
> > omap_device_fill_dma_resources(), we can actually split the function
> > into 3 resources and avoid duplication -
> >   - omap_device_fill_dma_resources()
> >   - omap_device_fill_mem_resources()
> >   - omap_device_fill_irq_resources()
> > 
> > Actually I wanted to clean it further but thought of getting
> > feedback first and then proceed further.
> 
> Well, that's anyway temporary code that should be gone in 6 months from
> now (ideally). So that looks pretty good to me.
> 
> >  arch/arm/mach-omap2/omap_hwmod.c             |   27 ++++++++++
> >  arch/arm/plat-omap/include/plat/omap_hwmod.h |    1 +
> >  arch/arm/plat-omap/omap_device.c             |   72 +++++++++++++++++++++----
> >  3 files changed, 88 insertions(+), 12 deletions(-)
> > 
> > diff --git a/arch/arm/mach-omap2/omap_hwmod.c b/arch/arm/mach-omap2/omap_hwmod.c
> > index 31ec283..edabfb3 100644
> > --- a/arch/arm/mach-omap2/omap_hwmod.c
> > +++ b/arch/arm/mach-omap2/omap_hwmod.c
> > @@ -3330,6 +3330,33 @@ int omap_hwmod_fill_resources(struct omap_hwmod *oh, struct resource *res)
> >  }
> > 
> >  /**
> > + * omap_hwmod_fill_dma_resources - fill struct resource array with dma data
> > + * @oh: struct omap_hwmod *
> > + * @res: pointer to the array of struct resource to fill
> > + *
> > + * Fill the struct resource array @res with dma resource data from the
> > + * omap_hwmod @oh.  Intended to be called by code that registers
> > + * omap_devices.  See also omap_hwmod_count_resources().  Returns the
> > + * number of array elements filled.
> > + */
> > +int omap_hwmod_fill_dma_resources(struct omap_hwmod *oh, struct resource *res)
> > +{
> > +	int i, sdma_reqs_cnt;
> > +	int r = 0;
> > +
> > +	sdma_reqs_cnt = _count_sdma_reqs(oh);
> > +	for (i = 0; i < sdma_reqs_cnt; i++) {
> > +		(res + r)->name = (oh->sdma_reqs + i)->name;
> > +		(res + r)->start = (oh->sdma_reqs + i)->dma_req;
> > +		(res + r)->end = (oh->sdma_reqs + i)->dma_req;
> > +		(res + r)->flags = IORESOURCE_DMA;
> > +		r++;
> > +	}
> > +
> > +	return r;
> > +}
> > +
> > +/**
> >   * omap_hwmod_get_resource_byname - fetch IP block integration data by name
> >   * @oh: struct omap_hwmod * to operate on
> >   * @type: one of the IORESOURCE_* constants from include/linux/ioport.h
> > diff --git a/arch/arm/plat-omap/include/plat/omap_hwmod.h b/arch/arm/plat-omap/include/plat/omap_hwmod.h
> > index 9b9646c..0533073 100644
> > --- a/arch/arm/plat-omap/include/plat/omap_hwmod.h
> > +++ b/arch/arm/plat-omap/include/plat/omap_hwmod.h
> > @@ -615,6 +615,7 @@ int omap_hwmod_softreset(struct omap_hwmod *oh);
> > 
> >  int omap_hwmod_count_resources(struct omap_hwmod *oh);
> >  int omap_hwmod_fill_resources(struct omap_hwmod *oh, struct resource *res);
> > +int omap_hwmod_fill_dma_resources(struct omap_hwmod *oh, struct resource *res);
> >  int omap_hwmod_get_resource_byname(struct omap_hwmod *oh, unsigned int type,
> >  				   const char *name, struct resource *res);
> > 
> > diff --git a/arch/arm/plat-omap/omap_device.c b/arch/arm/plat-omap/omap_device.c
> > index c490240..fd15a3a 100644
> > --- a/arch/arm/plat-omap/omap_device.c
> > +++ b/arch/arm/plat-omap/omap_device.c
> > @@ -486,6 +486,33 @@ static int omap_device_fill_resources(struct omap_device *od,
> >  }
> > 
> >  /**
> > + * omap_device_fill_dma_resources - fill in array of struct resource with dma resources
> > + * @od: struct omap_device *
> > + * @res: pointer to an array of struct resource to be filled in
> > + *
> > + * Populate one or more empty struct resource pointed to by @res with
> > + * the dma resource data for this omap_device @od.  Used by
> > + * omap_device_alloc() after calling omap_device_count_resources().
> > + *
> > + * Ideally this function would not be needed at all.  If we have
> > + * mechanism to get dma resources from DT.
> > + *
> > + * Returns 0.
> > + */
> > +static int omap_device_fill_dma_resources(struct omap_device *od,
> > +				      struct resource *res)
> > +{
> > +	int i, r;
> > +
> > +	for (i = 0; i < od->hwmods_cnt; i++) {
> > +		r = omap_hwmod_fill_dma_resources(od->hwmods[i], res);
> > +		res += r;
> > +	}
> > +
> > +	return 0;
> > +}
> > +
> > +/**
> >   * omap_device_alloc - allocate an omap_device
> >   * @pdev: platform_device that will be included in this omap_device
> >   * @oh: ptr to the single omap_hwmod that backs this omap_device
> > @@ -524,24 +551,45 @@ struct omap_device *omap_device_alloc(struct platform_device *pdev,
> >  	od->hwmods = hwmods;
> >  	od->pdev = pdev;
> > 
> > +	res_count = omap_device_count_resources(od);
> >  	/*
> > -	 * HACK: Ideally the resources from DT should match, and hwmod
> > -	 * should just add the missing ones. Since the name is not
> > -	 * properly populated by DT, stick to hwmod resources only.
> > +	 * DT Boot:
> > +	 *   OF framework will construct the resource structure (currently
> > +	 *   does for MEM & IRQ resource) and we should respect/use these
> > +	 *   resources, killing hwmod dependency.
> > +	 *   If pdev->num_resources > 0, we assume that MEM & IRQ resources
> > +	 *   have been allocated by OF layer already (through DTB).
> > +	 *
> > +	 * Non-DT Boot:
> > +	 *   Here, pdev->num_resources = 0, and we should get all the
> > +	 *   resources from hwmod.
> > +	 *
> > +	 * TODO: Once DMA resource is available from OF layer, we should
> > +	 *   kill filling any resources from hwmod.
> >  	 */
> > -	if (pdev->num_resources && pdev->resource)
> > -		dev_warn(&pdev->dev, "%s(): resources already allocated %d\n",
> > -			__func__, pdev->num_resources);
> > -
> > -	res_count = omap_device_count_resources(od);
> > -	if (res_count > 0) {
> > -		dev_dbg(&pdev->dev, "%s(): resources allocated from hwmod %d\n",
> > -			__func__, res_count);
> > +	if (res_count > pdev->num_resources) {
> > +		/* Allocate resources memory to account for new resources */
> >  		res = kzalloc(sizeof(struct resource) * res_count, GFP_KERNEL);
> >  		if (!res)
> >  			goto oda_exit3;
> > 
> > -		omap_device_fill_resources(od, res);
> > +		/*
> > +		 * If pdev->num_resources > 0, then assume that,
> > +		 * MEM and IRQ resources will only come from DT and only
> > +		 * fill DMA resource from hwmod layer.
> > +		 */
> > +		if (pdev->num_resources && pdev->resource) {
> > +			dev_dbg(&pdev->dev, "%s(): resources already allocated %d\n",
> > +					__func__, res_count);
> > +			memcpy(res, pdev->resource,
> > +				sizeof(struct resource) * pdev->num_resources);
> > +			omap_device_fill_dma_resources(od,
> > +					&res[pdev->num_resources]);
> > +		} else {
> > +			dev_dbg(&pdev->dev, "%s(): using resources from hwmod %d\n",
> > +					__func__, res_count);
> > +			omap_device_fill_resources(od, res);
> > +		}
> 
> Considering the temporary aspect of that, I'm more than fine with that
> approach.
> 

Thanks, once you test it on other platforms and based on observation we can 
merge this patch.

> BTW, did you attend the discussion about the DMA binding during PLC?
> Is this going to be finalized soon?
> 

I think you are getting confused between Vaibhav B and Vaibhav H :)
We have two Vaibhav's roaming around here ;-)


I was not there during LPC this time, it was Vaibhav B who attended it.
I will sync up with him and try to get more info on it.

Thanks,
Vaibhav



More information about the devicetree-discuss mailing list