[PATCH 6/6 v6] cpufreq, highbank: add support for highbank cpufreq

Shawn Guo shawn.guo at linaro.org
Thu Nov 29 01:58:02 EST 2012


On Wed, Nov 28, 2012 at 07:16:12AM -0600, Mark Langsdorf wrote:
> Standard practice is to have cpufreq_set_target() handle voltage
> transitions and leave clk_set_rate() handle the frequency changes.

The standard practice is to have cpufreq_set_target() handle both
voltage and frequency transitions, while voltage is handled by regulator
and frequency by clk API.

> I'd
> have to move most of the logic of hb_set_target() into
> clk_highbank.c:clk_pll_set_rate() and then add extra logic for when
> cpufreq is not enabled/loaded.

You only need to move hb_voltage_change() into cpu clock's .set_rate()
hook with no need of checking if cpufreq is enabled or not.

> I don't think the clk maintainers would
> take that patch, either.

This is all handled platform clock specific .set_rate() hook.  I doubt
it will concern clk maintainers at all, especially when doing so we
will avoid another cpufreq driver by just using cpufreq-cpu0 driver.

Shawn



More information about the devicetree-discuss mailing list