[PATCH v4 05/11] pwm: pwm-tiecap: pinctrl support

Philip, Avinash avinashphilip at ti.com
Fri Nov 23 22:12:15 EST 2012


On Fri, Nov 23, 2012 at 16:21:10, Thierry Reding wrote:
> On Fri, Nov 23, 2012 at 10:34:02AM +0000, Philip, Avinash wrote:
> > On Fri, Nov 23, 2012 at 02:29:44, Thierry Reding wrote:
> > > On Wed, Nov 21, 2012 at 06:41:02PM +0530, Philip, Avinash wrote:
> > > [...]
> > > > +	pinctrl = devm_pinctrl_get_select_default(&pdev->dev);
> > > > +	if (IS_ERR(pinctrl))
> > > > +		dev_warn(&pdev->dev, "failed to configure pins from driver\n");
> > > 
> > > I think we already discussed this, but shouldn't this be a fatal error?
> > 
> > I had checked relevant discussion and found this can be warning message.
> > This is because most boards don't have pinctrl implemented at this point,
> > or may never have.
> > 
> > https://lkml.org/lkml/2012/9/11/369
> > 
> > Any way I will change to
> > dev_warn(&pdev->dev, "unable to select pin group\n");
> > as in other drivers.
> 
> But in case pinctrl isn't implemented, shouldn't the implementation of
> devm_pinctrl_get_select_default() just be a no-op?

So driver can still exist but pin mux functionality missing. Then warning
message will give hints.
I am also ok with error message & failure of driver with EPROBE_DEFER,
if you want?

Thanks
Avinash

> 
> Thierry
> 



More information about the devicetree-discuss mailing list